|Prev||Professional Automotive Repair Technical Discussions for June 3, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2000 Chrysler 300M 3.5L Battery VIN: 2C3HE66G2Y
Client towed vehicle to shop with dead battery. Performed battery test. Battery failed test after re-charging. Replaced battery. Tested battery with snap-on d-tac plus battery and charging system analyzer. Battery passed load and capacity test after replacemen...
|2007 Chrysler PT Cruiser 2.4L cooling fans VIN: 3A4FY48B77
Cooling fans are not turning "ON" automatically.I can not turn them on with a scan tool.I an trigger them On with the relays by supplying the ground.My next test was to check the control module but I can not find it.The schematic says its in front of the radia...
|2002 Dodge Ram 1500 Van 5.9L Charging VIN: 2B6HB11Z52
2002 dodge ram van with the 5.9 360 v8, van was not charging when arrived at shop, replaced alternator. van charges then voltage gauge drops to nothing and stalls. does this every 5 minutes. if you keep steady throttle pressure to it, it seems not to do this. ...
|2008 Jeep Grand Cherokee SRT8 6.1L Starting VIN: 1J8HR78388
This vehicle originally was brought to us with overheating and check engine light/ misfire concerns. We found a dead ignition coil and corrected the misfire. we replaced a thermostat due to lack of flow. The vehicle came back after reportedly overheating, but...
Fixes & Summaries for Chrysler
|1999 Chrysler Concorde LXi 3.2L No Start VIN: 2C3HD46J3X
Thank you for the help. Dan, thanks for the picture of the fuel pump isolation tool you made. I put together a similar set up to isolate the fuel pump from the injectors. The injectors were not leaking. The only leak on this vehicle was the fuel pump. I r...
|1999 Jeep Cherokee Limited 4.0L evaporator VIN: 1J4FF78S9X
Tried overcharging system in small increments to increase pressures to specification (approximately 30 lbs. low side/ 200 lbs. high side) as other techs have suggested, cooling became less effective than before. Flushed evaporator and condenser with A/C flush ...