|Prev||Professional Automotive Repair Technical Discussions for May 31, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2000 Dodge Neon ES 2.0L Hesitation
have hesitation at 1500 RPM, in or out of gear, has had the same hesitation before and after rebuild, new plugs, new wires, new TPS, fuel injection service, induction service, no vacuum leaks, new 02 sensor, no change..
|2001 Dodge Intrepid ES 2.7L No Start VIN: 2B3AD56JX1
Cant seem to figure this one out guys. I know these are very common for timing belts but can't seems to be sure if that's the case. I've checked my crank signal and it looks good but I don't have any signal on the cam and I've checks the ground,8 volt referenc... Trouble codes: P0700 (Trans fault present), P1391 (Intermittent loss of camp or ckp), P0240 (No cam signal at PCM)
|2003 Dodge Caravan SE 2.4L No Start VIN: 1D4GP25B93
Thank you for taking the time to look at this. I have installed countless PCM's and this is the first time I have run into this problem. I installed a PCM purchased from my Dodge dealer ordered by VIN. I hooked up my DRBIII and programmed the VIN and the milea...
|2008 Dodge Grand Caravan SXT 3.8L shifting VIN: 1D8HN54PX8
replaced with a used unit , did the proper fluid chart setting , cleared codes and test drove tranny never tried to shift at all , we are getting a p0731 code , it was also there before replacement , we appear to have speed sensor signal we see rpm , and speed...
Fixes & Summaries for Chrysler
|2008 Dodge Grand Caravan SXT 3.8L Stall
I got no help with wave forms but car is fix, I wanted to make sure my timing was correct before tear down. it actually need head job, carbon built up on valves that was causing it to misfire on rear head only