Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 21, 2014
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1975 Ford F-250 Ranger 6.4L Hesitation, Surge, Cuts out, Stall, Misfire VIN: F25MRW4041
I have a 1975 ford f 250 ramger with an old 390 in it it came to us because of a [...] we replaced the cylinder heads with new ones and new valves because the old ones were cracked the truck now idles and runs better but there is still a misfire in cylinder...
View
2007 Ford Freestar SE 3.9L Engine VIN: 2FMZA51617
We have a van with a misfire (p0303) and B2S2 Lean(P0174). It is also making a popping noise through the intake and a popping in the drive belt. we have replaced the O2 sensor, injectors, Plugs and wires, coil,complete valve job, and all new gaskit set. New PC...
View
2009 Ford F-150 FX4 5.4L Brake Lights VIN: 1FTPX14V99
Ford techs and fellow techs, the brake lights come on in this vehicle with key off. They will turn on, then off, then on, sometimes will stay on until battery is disconnected. Customer replaced brake switch. Checked switch operation and it looks ok. Brake ligh...
View
1995 Lincoln Town Car Cartier 4.6L Poor Idle Quality VIN: 1LNLM83W8S
This Lincoln originally came in with rough idle & stalling. we replaced iac solenoid & did an induction cleaning but no throttle body cleaning. The car then would stall & run rough after warmed up, so we tested for intake leaks and found & replaced faulty inta...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1991 Ford F-150 Custom 4.9L No Start VIN: 1FTDF15Y3M
Well after checking all the powers and grounds I was leaning toward the ECM. I took the ECM out and took it apart. BINGO! There was a burn mark on the circuit board. Replaced the ECM and it fired right up. A big thank you for everyone who replied!
26
2002 Ford F-250 Super Duty Lariat 7.3L Injector VIN: 1FTNX20F22
haven't fixed this one yet, will be checking the injector cup, glow pugs, and scoping the cylinders for raw fuel. thanks for the replies time is up for my post and will definitely post the fix when completed
16
2008 Ford Taurus SEL 3.5L engine VIN: 1FAHP24W08
first let me say thank you to everyone who had input on this vehicle and it turned out that the vehicle was one tooth out of time on bank one replaced timing chain and this took care of this again thanks for all of your help.
6
2011 Ford F-150 STX 3.7L No Start VIN: 1FTEX1CM3B
I would like to thank all who responded.Frank and Ross expecially this truck had 120 ohms on the high speed network and 60 ohms on medium speed net work. on the high speed network when I disconnected the bcm the circuit went open,I was trying to figure out whi... Trouble codes: U0100, U0151, U0422.
10
2005 Lincoln LS Sport 3.9L Circuit VIN: 1LNHM87A45
Pin 28 did not pull voltage to ground I have dave and bill at identifix to thank for this info there was none for voltage test only for omh switch testing.. They got a like year car and completed know good test for us omg really wow is all I can say.
5
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next