|Prev||Professional Automotive Repair Technical Discussions for May 7, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2004 Chrysler PT Cruiser Limited 2.4L Poor Idle Quality, Cuts out, Stall, Misfire, MIL Lamp on VIN: 3C8FY68814
Complaint of would not idle, barely limped to my shop and the check engine light came on. Found other posts with the same concern but no resolution. No accident and visually cannot see any issues of corrosion, melted or rubbed through harness. Let run but did ... Trouble codes: P0038, P0032, P0508 (IAC Current low), P0452 (NVLD Stuck Closed), P0300 (Random Misfire)
|2005 Dodge Durango SLT 4.7L Misfire VIN: 1D4HB48N35
Stumped on this one guys/gals. Customer brought in vehicle with check engine light on and multiple misfire and cyl. 8 misfire codes. Replaced all 8 plugs, extremely worn out and #8 coil had burn hole in side. Customer just brought it back with cyl. 8 misfire c... Trouble codes: P0308 (Cylinder 8 misfire)
|2005 Dodge Dakota SLT 4.7L No Start VIN: 1D7HW48NX5
Greetings ladies and gentlemen: Customer states that the vehicle doesn't start; no starter engagement. Customer states he was previously having a problem with the vehicle not starting on first attempt. He states that at that time the starter would engage and t...
Fixes & Summaries for Chrysler
|2001 Dodge Stratus SE 2.4L Cuts out, Misfire, MIL Lamp on VIN: 1B3EJ46X11
Thanks for all the great replies. Joe from Jersey nailed this one as well as Raymond from Maryland and Sherman [...] on Demands diag for P1391, not on... Trouble codes: P1391 (Loss of cmp cpk signal).
|2002 Dodge Caravan SE 3.3L No Start VIN: 1B4GP25392
Thanks to Dan from TX Larry from NY and Bruce from Iowa this one is fixed. It turn out to be a plugged Catalyst. I was just to hung up on that Ethanol percentage to cover all the bases. A simple vacuum tester told the story NO VACUUM! That just goes to show yo... Trouble codes: P0171 (System too lean b1).
|2004 Dodge Ram 2500 SLT 5.9L isolation valve VIN: 3D7KU28C64
swapped frt sensor wires at cab-problem moved to rt side.lab scoped lt sensor-nothing but a clean ac sine wave.scoped rt sensor-had a dogleg in the pattern about every 20 teeth.Removed rt sensor and found a single tooth broken off tone ring inside brg.Replaced...
|2008 Dodge Ram 2500 SLT 6.7L drivetrain VIN: 3D7KS28A38
Hey all, finally got to check this truck out again,test drive it for about 10 miles , then checked the ujoints, and found that the rear ujoint on the rear shaft was warmed up,pulled driveline and lo and behold,we had a bad joint.replaced and all is well.The re...
|2012 Dodge Grand Caravan SXT 3.6L Brakes
Hello all, sorry for the delay in posting the fix, it was much simpler than i thought, just for anyhow i took the old reservoir and turned it upside down to simulate full fluid and plugged it in and bingo the light went out! I had previously tapped on the new ...
|2008 Jeep Grand Cherokee Laredo 3.0L transmission VIN: 1J8HR48M78
Thanks to all. Wiring harness at top of tranny containing wires to speed sensors was rubbing on engine causing chaffing and green corrosion. Harness had no short just high resistance. everything is good. Cruise codes were not related to this issue. Thank you f...