|Prev||Professional Automotive Repair Technical Discussions for May 1, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1987 Ford F-150 Custom 5.0L No Start, Stall VIN: 1FTCF15N0H
Engine will stall,wont restart or wont start sometimes-has fuel pressure when problem occurs-Here is my question:it will run as long as the key is in the start position-shuts off when you let off the key-I know I've seen this before but cant remember the fix-d... Trouble codes: 21 (Ect out of range), 18 (No tach), 25, KN0CK, SENS0
|1992 Ford F-350 XLT Lariat 7.3L converter VIN: 1FUYGFVBK8
i rebuilt transmission for slipping.after install stalls when put in reverse and hunts between 2nd and third at steady speeds.recently replaced vss and replaced converter during rebuild.not sure what to do next
Fixes & Summaries for Ford
|1999 Ford F-350 Super Duty Lariat 5.4L slip with heavy load and torque converter lockup VIN: 1FTSF31L2X
the pickup is still having converter lockup issues. reading up on other forum websites i learned that other manufactures have had issues with the converter clutch control valve in wearing and leakby. im going to dissassemble the transmission front pump and mea...
|1999 Ford Escort ZX2 Hot Coupe 2.0L Surge VIN: 3FAKP1131X
What we did was tweak the idle stop, while watching TPS and IAC values. We started at .82V. Finally settled on .86, with 19% IAC. Did the hard reset and relearn again, base idle is much better, though there is a 200rpm flare when the AC turns on. But it is acc...
|2003 Ford Windstar LX 3.8L lights locks VIN: 2FMZA51423
good evening all thanks to paul and michael ended up being bad fuse block terminals was rotted away behind the fuse box thanks again for the help
|2006 Ford F-250 Super Duty XLT 5.4L Steering VIN: 1FTSW21506
Well Guys, thanks for all the info. I did the best I could to check and test all the parts that I thought were related. I made recommendations to cust and only wanted the steering damper changed. Possible cause I made it seem like this would fix it. I tested a...