|Prev||Professional Automotive Repair Technical Discussions for April 10, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for GM
|2005 Chevrolet Silverado 2500 HD 6.0L injectors VIN: 1GCHK24U25
hello all thanx in advance for your help.this vehicle came in as a hard start when cold replace fuel pump due to psi readings below 40 psi. fuel psi stays stedy @ 55 psi now. still when cold has hard starting,runs very low rpms and logs missfires on 1,4,5,7 bu...
|2007 Chevrolet Silverado 1500 LTZ 5.3L vavle body VIN: 2GCEC19J77
I am hoping for some insight on this 4l60e. I have not yet been able to duplicate the problem but the customer claims that while she is sitting at a traffic light with the trans in drive she will suddenly feel a good stiff "bump" almost as if someone had run i...
|2003 GMC Safari 4.3L Misfire, MIL Lamp on VIN: 1GKDM19X23
HI.I have a miss fire # 3 cylinder @ idle in closed loop warm.Compression test leak down test all check good.Ignition @ fuel tested good.The miss fire will go away when I hold pressure on # 3 cylinder exhaust rocker arm running @ idle.I already replaced all th... Trouble codes: P0303 (Miss fire)
|2007 GMC Acadia SLT 3.6L trans VIN: 1GKEV23707
Hello GM tech's. I've replaced this automatic trans and I'm curious if I need to reprogram the TCM to the PCM in order to get proper trans function. I know I need to perform an adaptive learn procedure but I'm not too sure if a reflash is necessary to complete...
Fixes & Summaries for GM
|2007 Pontiac Grand Prix GT 3.8L Shifting VIN: 2G2WR55447
Line pressure is good, no reverse, checked input speed on scanner = 0. Broken input shaft. Probably aggravated by a bad pressure control solenoid.