 Prev |
Professional Automotive Repair Technical Discussions for February 19, 2014 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1998 Dodge Ram 1500 ST 5.2L Won't run O2 htr mon VIN: 3B7HC12Y1W This truck came in with a P0500 code, no vehicle speed signal. Found a broken wire between the ABS module and PCM. Repaired that wire, now the speedo works, and code does not re-appear. The problem is that the O2 Heater monitor will not run. All the other mon... |
View | |
| 2003 Dodge Dakota SLT 4.7L Stall VIN: 1D7HG42N03 Help Dodge Techs!! This Dakota stalls intermittently at stops hot- we have never been able to duplicate concern. The customer states if he slightly taps the throttle when the idle starts to drop it will stabilize and continue to idle normally until he accelera... |
View | |
| 2004 Dodge Intrepid ES 3.5L Display VIN: 2B3HD56M54 The desired temp display on the climate control head goes out after engine is started, it will stay on with the key in the run position, but goes blank after engine is started. The system works normal, can set the system to what you want just no temp display, ... |
View | |
| 2002 Jeep Liberty Limited 3.7L engine VIN: 1J4GL58K32 I can drive this car for ten to fifteen miles or more with or without AC on and all at once the temp starts to climb. I removed the thermostat and that seem to delay the time it takes to get hot but it still gets hot. Customer told me after I did the Job that ... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2010 Chrysler Sebring Touring 2.7L Blend Door VIN: 1C3CC4FD6A Heater core was plugged. Replaced it and flushed out the system. Thanks to all who offered information. |
9 | |
| 2002 Dodge Intrepid SE 2.7L Engine VIN: 2B3HD46R42 Well, this one is going to the dealer. Thanks for all the responses. Ive replaced PCM, I have removed cleaned and checked every connection in relay/fuse under hood panel. Ive checked all grounds and I have checked every plug in connector that I could possibly ... |
9 | |
| 2005 Dodge Grand Caravan SE 3.3L No Start VIN: 1D4GP24R25 Well this ones fixed, some of you's said that it had to be a wireing issue because of the horn circuit not haveing anything to do with the PCM, and I had to agree, changed the PDC, no difference, again checked power and grounds to PCM, traced wireing from melt... |
6 | |
| 2002 Jeep Liberty Limited 3.7L engine VIN: 1J8GK58K42 well i got this one fixed. odered replacement balancer and installed vibration is history. old balancer looked just fine and timing mark on new balancer was in same relation to keyway as old balancer but holes drilled in outer ring were off by about 90 degrees... |
14 |
