|Prev||Professional Automotive Repair Technical Discussions for January 27, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2004 Dodge Grand Caravan SE 3.3L Misfire VIN: 1D4GP24R24
HELP, replaced plugs and plug wires for maintenance. 1 month later comes in for misfire, no spark from coil to #5 cylinder. Replaced coil(BWD) runs great. 3 weeks later same thing, another BWD coil runs great. 3 weeks again no spark, always #5. Replaced coil a... Trouble codes: P0305
|2005 Dodge Magnum SXT 3.5L driveshaft VIN: 2D4FV48V35
Ok I have been doing this for a very long time and have never seen a driveshaft do what this one is doing. Frist this car came in for a valve job low compression on #1 dead miss. it's for a large used car chain. It has been shipped back to us now 3 times claim...
|2008 Dodge Ram 1500 SXT 5.7L Stall VIN: 3D3KS19D88
customer complains his truck stalls only after he puts in gear , only when cold though -10 and below . all else looks good with no other driavabiliy issues . when its warm its fine . we think its the original trans fluid but he could not answer definitively.
Fixes & Summaries for Chrysler
|2007 Chrysler Pacifica Touring 4.0L starter VIN: 2A8GM68X17
well thanks so much to Robert, William,Jason,Daniel and Keith for the replies that i recieved. i did check the trans ground and it was clean and tight. i decided to check the PCI BUS at the dlc. i had steady 0 volts. so after looking at wiring diagram i found...
|2000 Jeep Cherokee Sport 4.0L Head lights VIN: 1J4FF48S5Y
So i get to drive the jeep Saturday night and no light flash no flicker nothing. I have to close this request because ITAN says i need to. thanks for all the ideas.
|2007 Jeep Grand Cherokee Laredo 3.7L knocking noise VIN: 1J8GS48K87
Well finally this car repair came to and end, after we remove the engine to check for a problem with the cylinder walls, the piston, the rods, everything was ok, the guy from machine shop check it very well and no problems were found (machine shop guy is very ...