|Prev||Professional Automotive Repair Technical Discussions for December 2, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|2006 Ford Mustang GT 4.6L Oil pressure VIN: 1ZVHT82H06
Almost identical problem as before. When engine reaches operating temperature, oil pressure falls to 25, then 20psi, dash warning display reads "oil pressure low," and on occasion the engine will rattle from the chain and run rough, likely from the tensioners ...
|2000 Mercury Cougar 2.5L forward VIN: 1ZWFT61L1Y
This Cougar will not move forward when the weather is below freezing and after sitting for 2 or more hours. If I let the car warm up for 30 minutes it will move right away and on warmer days it will move right away. It will go in reverse even when cold but not...
Fixes & Summaries for Ford
|2001 Ford F-250 Super Duty Lariat 7.3L fuel leak VIN: 3FTNW20F11
Thanks for your help. All of you were correct. The bad part was the drain. Ford had plenty in stock. Easy repair.
|2003 Ford F-550 Super Duty XL 6.0L No Start VIN: 1FDAW57P63
Thanks for all the replies. Long crank time with no start will set the cam code. my pressure was low only 250 psi so we replaced the high pressure pump also removed the IPR and the screen was full of blue gasket. Removed the oil cooler and the gasket was flaki...
|1997 Lincoln Mark VIII 4.6L taillights&parking lamps VIN: 1LNLM91V0V
Got a second used module reprogramed all is fine Thanks for all the replies left the decklid lights unpluged Unit (ballast) is no longer available not worth taking a chance with a used unit Module was very hard to find
|2002 Mercury Sable GS 3.0L MIL Lamp on VIN: 1MEFM50U12
HELLO TECHS TIMES UP GOTTA CLOSE THIS HELP REQUEST DOWN, CUSTOMER HAS NO FUNDS FOR THIS 600.-800.DOLLAR PCM+ PATS KEY SERVICES + ALSO CAR RUNS NEW STILL. HAD MITCHELL WIRING DIAGRAM TO FURTHER INSPECT ALL LOOKED RITE. AT LAST SCANNER HOOK-UP HAD PO340 CAM SENS... Trouble codes: P1504.