|Prev||Professional Automotive Repair Technical Discussions for October 1, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2004 Chrysler Town & Country (Van) 3.3L Wipers VIN: 1C4GP45R44
Customer had taken vehicle to dealership for problem with wiper blades intermittently stopping in middle of windshield. Dealership said they could find nothing wrong. What I have found is the supply voltage for the wiper motor when properly working is about 1...
|2003 Dodge Dakota 3.9L No Start VIN: 1D7HL12X53
no bus only 4,5 volts at at all 5 volt sensors, unplug all sensers on 5 volt circit time out system only 4.5 volts, cut 5 volt wire at pcm ,slillonly 4.5 on pin 17 pcm output,we still 4.5 volts on
|2005 Dodge Ram 2500 Truck Laramie 5.9L engine VIN: 3D7KS28C55
Knocking noise more prevalent as the engine get’s to running temp. Have sent off oil sample and it came back, “No Action Required" all wear medals (ppm) normal. The knock can be heard right after the engine is turned off, from underneath the truck it sounded l...
|1998 Jeep Grand Cherokee Laredo 5.2L fuse #20 VIN: 1J4GZ58Y3W
vehicle came into my shop on the hook. complaint of crank no start. found number 20 fuse blown, replaced fuse and battery, vehicle left only to return today with the same fuse blown. tried to find what this fuse controls but to no avail. what i really need hel...
|2001 Jeep Wrangler SE 4.0L MIL Lamp on, alt not charging VIN: 1J4FA59S51
replaced pcm for no charge condition-works fine for about a week and then quits charging-have checked all wiring to alternator and leak detection pump-replaced alternator for possible internal problem-pcm is reman Chrysler-checked resistance of ldp on car vers... Trouble codes: P0622, P1491
Fixes & Summaries for Chrysler
|2002 Jeep Grand Cherokee Laredo 4.0L gauges VIN: 1J4GW48S62
we went and doubled checked all our powers and grounds to the ecm,all checked well.we decided to install anew ecm and jeep fired right up.thanks to all replies.