|Prev||Professional Automotive Repair Technical Discussions for September 23, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2001 Chrysler LHS 3.5L instrument cluster VIN: 2C3AC56G71
customer came for diagnosis on the instrument cluster inoperative. the only thing that i see is the ODO light, transmission gear indicator lights and the engine oil light when the ignition switch is turned on. the car works fine, I have comunication with all t...
|2004 Chrysler PT Cruiser Touring 2.4L No Start, Cuts out, Stall, MIL Lamp on VIN: 3C4FY58804
Hi fellow technicians, Ive had this 2004 PT Cruiser Turbo Touring come back multiple times over the past 2 months for the same problem... it keeps stalling/ cutting out when driving .. it just shuts off. It will restart if you wait a few minutes turn key off t... Trouble codes: P0032 (B1S1 Oxygen Sensor heater circuit high), P0038 (B1S2 Oxygen Sensor heater circuit high), P0508 (IAC Valve Sensor Ciruit Low)
|2007 Chrysler PT Cruiser GT 2.4L Engine VIN: 3A8FY78G67
Got a job to replace the timing belt and water pump on this PT. The job went fine, the marks lined up and ran good with no codes. We did notice the engine was vibrating too much at idle. We did the drivetrain alignment procedure we found but noticed the torque...
Fixes & Summaries for Chrysler
|1994 Jeep Grand Cherokee Limited 5.2L air bag VIN: 1J4GZ78Y4R
Thanks to all that answered my request . I found connector under passenger front seat . I did not have correct adapter with d.r.b. scan tool so could not pull codes at this time . Customer will return car at later date .
|2008 Jeep Wrangler X 3.8L starter VIN: 1J4FA24178
Don and Matt nailed it on the head. Redundant ground issue. We added a negative battery cable from battery to the engine block. For some reason our voltage drop measurement on the ground side, .3 to .4 drop didn't trigger the proper initial response of lets...