|Prev||Professional Automotive Repair Technical Discussions for September 13, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2004 Chrysler Pacifica 3.5L Blower VIN: 2C8GM68424
We have a continuuing problem with this Pacifica. Customer states after driving awhile, blower motor goes down to very slow speed. Its moving but will not blow air. Motor checks good everytime we test it. Powers and grounds are good. Signal is good to and from...
|1989 Jeep Wrangler 2.5L Stall VIN: 2J4FY19E9K
This jeep has a pulse width on an oscilloscope when you crank it, but as soon as it starts the pulse width goes to 0. If you move the gas pedal it comes back, but as soon as the gas pedal becomes stationary it cuts to 0 again. To keep this truck running you ha...
Fixes & Summaries for Chrysler
|2006 Chrysler 300 (Car) C 5.7L Front differential VIN: 2C3KK63H46
Would like to THANK ALL who replied to my request for help. Would really like to THANK SKYLER from NEBRASKA!!! The fix was the exhaust hitting the trans crossmember on left turns. Heated and adjusted exhaust and noise is gone. Thanks again!!!
|2008 Dodge Grand Caravan SE 3.3L dash lights VIN: 1D8HN44H58
ok guys found the problem thanks for all the replys it was a few broken wires in between the front door had like 5 broke customer just wanted them repaired really need to replace the harness but she didnt have that kind of money again thanks
|2003 Jeep Grand Cherokee Overland 4.7L a/c VIN: 1J8GW68J63
Just as everyone said I replaced Expansion Valve and all is good, Pressures are normal and [...] out of vents. Thanks to everyone who replied I have never come across this before and I really thought that if I had a restriction or a problem with the valve ...
|2003 Jeep Wrangler Rubicon 4.0L engine VIN: 1J4FA69S53
we checked the condition of the crankshaft and found that all the bearing journals were scored slightly and had a rust colored tarnished appearance and bearing clearance on all rods,mains and end play were at the max spec,the camshaft was not removed for inspe...