|Prev||Professional Automotive Repair Technical Discussions for August 3, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|2007 Honda Odyssey EX 3.5L door locks, keyless entry, turn signals, high beam VIN: 5FNRL38667
This is my wife's van and it worked fine until this morning. Keyless entry inop, then found electric door locks inop from either front switchs. Wipers only work on low speed, low beam lights work but turn signals and high beams inop. Checked all fuses under ho...
|2004 Hyundai Santa Fe GLS 2.7L Ecu VIN: KM8SC73DX4
Vehicle was driving fine had a sudden stumble cleaned up and drove fine again 10 minutes later arrived at destination, turned engine off 5 minutes later would not start. Tow to shop and start to Diagnose No Spark at Plugs No Pulse at injector, No Power at ECU ...
|2000 Nissan Maxima GLE 3.0L starting VIN: JN1CA31D0Y
Good evening i have this 2000 Maxima that does not start. I have 125psi on all cylinders, excellent spark and injector pulse. Codes present are P1320, P1131 and P1165. I went through the system but cant seem to find anything. I'm stumped. Any and all help will...
|2000 Toyota Sienna LE 3.0L Excessive Emissions, Misfire, MIL Lamp on VIN: 4T3ZF13C5Y
Got P1130 and P1135; quickly assumed that due to mileage and codes the sensors should be replaced. Wondering if I am overlooking anything prior to replacement; any advice would be appreciated. Have a good weekend! Trouble codes: P1130 (Air Fuel Ratio Sensor No. 1 Bank 1), P1135 (Air Fuel Ratio Sensor No. 1 Bank 2)
Fixes & Summaries for Asian
|2008 Kia Sorento LX 3.3L engine VIN: KNDJC73518
sorry for taking so long to post. Customer could not decide what to do with her car so she traded it in. We wanted to install a new oil pump to correct our 94 psi oil pressure at idle hot motor. we felt this was causing our valve timing issues. Again thanks fo...