|Prev||Professional Automotive Repair Technical Discussions for June 28, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2003 Chrysler Sebring LX 2.4L battery VIN: 1C3AL46X53
alternator is charging, when start up its good few seconds all lights begin to flicker, tested battey it failed a loadtest, alternator is charging but going up & down 13.5-15.0 volts, we replaced alternator still dose the same thing, pcm is sending a 5.0 volts...
|2000 Dodge Ram 1500 Van 3.9L Poor Idle Quality, Surge, Cuts out, Stall VIN: 2B7HB11X8Y
vehicle after warmed will start to run rough and sometimes die sometimes clear up customer removed the cat replaced fuel pump dist cap rotor button plugs and wires. I have replaced b1 snr2 o2 because o2 codes were present still has evap codes fuel pressure doe... Trouble codes: P0443, P0138
|2000 Dodge Ram 3500 Truck 5.9L No Start, Poor Idle Quality, Stall VIN: 1B7MC3364Y
Customer had this vehicle towed in for stalling and occasional no start. Checked and found two trouble codes P0121 and P0336. Replace crank sensor under warranty because we replaced it about nine months ago because of a no start. Found connector to fuel heater... Trouble codes: P0121 (throttle pos sensor), P0336 (Crankshaft position sensor)
Fixes & Summaries for Chrysler
|1996 Chrysler Town & Country (Van) LXi 3.8L No Communication VIN: 1C4GP64L1T
We have fixed the van. Thanks for all your help. What we did was replace the pcm and our problem was taken care of. Thanks again for all the help. Christopher
|2007 Dodge Sprinter 2500 3.0L Stall VIN: WD0PE74567
I checked over the wiring harness for problems in the injector areas of concern. Harness seemed ok. Cleaned up all the grounds and found some corrosion on a few of them. Vehicle has been running for over a week now with no problems. Thanks Again Mike Trouble codes: P2125 (Injector bank2), P2503 (1 circuit), P2504 (2 circuit), P2505 (3 circuit), P2506 (4 circuit), P2507 (5 circuit).