|Prev||Professional Automotive Repair Technical Discussions for May 31, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|2006 Ford E-450 Super Duty 6.8L Rear Diff Housing VIN: 1FDXE45S16
Hey everybody, Having problems tracking down a used diff for this unit. It is a Dana 70 HD 456 gears 60" back to back 49.5" pin to pin 5 bolt (not 4) axle flange mounting, dually. E450 stripped chassis application. It has 10 bolt diff cover. If anyone has one ...
Fixes & Summaries for Ford
|1998 Ford Explorer Eddie Bauer 4.0L timing chain VIN: 1FMZU32E5W
On the Cloyes right side jack shaft sprocket you can see a mark from the bolt flange and it is not centered. But it is a minute amount. After considering the replies and info from Ford techs I had the customer in to show and tell our delima. We discussed optio...
|1999 Ford Ranger XL 3.0L piston VIN: 1FTYR14V5X
After reading your responses we will not be doing this swap. About the only thing that would not have to be changed (maybe) is the lower intake manifold. There were concerns about a different firing order, but Alldata does show it to be the same. Even though i...
|2000 Ford E-250 Econoline 5.4L No Start, Stall VIN: 1FTNE24L0Y
First, THANK YOU for your replies. Come to find out this Van had been sitting for 1 1/2 years on a 1/4 tank. Clean out the fuel system new gas and HEY !, she runs ! Thanks again.
|2001 Ford Taurus SE 3.0L Alternator VIN: 1FAHP53U71
Well this is fixed -sorta! First, thanks for all the help and insight into this problem! We retested all grounds and load circuit wiring and no volt drop over 0.03v recorded. Finally, bit the bullet and installed a NEW motorcraft alternator and wala, bulb c...
|2006 Ford F-250 Super Duty XLT 6.0L No Start VIN: 1FTSX21P86
Well, this was a long and painful process. The final results are that the high pressure oil pump was bad and all eight injectors were bad as well. From what I discovered through many different sources the numbers in the scanner for high pressure are not to b...