 Prev |
Professional Automotive Repair Technical Discussions for February 17, 2013 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2008 Chrysler 300 LX 2.7L 1-2 shift VIN: 2C3KA43R38 I cannot check the fluid level or condtion as there is no trans dip stick for this car.It has a plug only where the dip stick goes and appears factory.The concern is a hard shift when cold.I found a bulitin on mitchel,but it stated it's refernece to a 300 with... |
View | |
| 2003 Dodge Ram 1500 Laramie 4.7L Stall VIN: 1D7HU18N43 complaint, wouldn't run over 60 mph on highway, poor idle.upon inspection wouldn't start. checked fuel-45 lb, checked firing -ok .finally got started. runs good for first 3 minutes...then stalls, runs rough.scan test poo38 for bank 1 sensor 2 oxygen sensor = r... Trouble codes: P0038, P0522, P0700 |
View | |
| 2004 Dodge Neon SXT 2.0L MIL Lamp on VIN: 1B3ES56C64 this car will intermittently set po344 and i think it goes to limp mode,limits rpm and seems to cut fuel over [...].on restart runs fine.anyone have a confirmed fix on this? the exhaust info is erroneous. i dont have that stuff and it wouldnt send with out ... Trouble codes: P0344 |
View | |
| 2005 Dodge Caravan SE 3.3L alternator VIN: 1D8GP25E65 battery light not on not verified,dtc po563 overcharge cond.,voltage drop on gen.field grd O.k.,contiuity check between C2 19 field control and C2 38 iac control o.k.,when either gen. field or iac control are controlled individually through scan tool both are ... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2005 Dodge Ram 1500 ST 5.7L camshaft VIN: 1D7HU18D25 Engine repaired. Pulled heads, cam, and oil pan. Cam bearings, rod and main bearings looked pretty decent yet. Cleaned pan and inspected oil pump Pitting on most lifter rollers and on a few lobes of camshaft. #2 exhaust lobe gone. Replaced cam, lifters pushrod... |
9 |
