|Prev||Professional Automotive Repair Technical Discussions for February 11, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2005 Chrysler Town & Country (Van) Limited 3.3L Lights VIN: 1C4GP45R35
Customer has a problem with exterior and interior dash lights flickering at times. I am not sure what to look for that might cause this problem. The charging voltage is steady at 13.8 volts. I did not find any TSB's related to this. Customer says it's and inte...
|2005 Chrysler Town & Country (Van) Limited 3.3L lf caliper VIN: 2C4GP44R95
4 wheel disc brakes. Came in complaint "brake pedal goes to floor". Confirm, ck for leaks-none. order master cylinder bench bleed. Install bleed at mc fittings. Still had air in system. Start bleed on vehicle. LF caliper air first then fluid. Strange no fluid ...
|1991 Dodge Stealth ES 3.0L Poor Idle Quality VIN: JB3XD54B7M
For the past three years the customer has had problems with a high idle above 1800 rpms while cold and no one including myself have been able to identify the problem and or the source of the problem. I have performed thorough scans and relearns and still no su...
|2004 Dodge Stratus R/T 3.0L central locking, DLC, hazards, blower, +12 outlets VIN: 4B3AG52HX4
I purchased this vehicle Saturday. The seller stated the blower worked intermittently, but had recently became completely inop and another shop had told him the control head needed replaced. On the trip back from picking up the vehicle (250 miles), I noted th...
|2011 Jeep Grand Cherokee Laredo 3.6L Misfire VIN: 1J4RR4GGXB
Vehicle came in with misfire code P0302. Changed plugs and #2 coil. Still have P0302 code and a misfire. Listened to #2 injector with stethoscope and it is clicking. Any suggestions? Trouble codes: P0302 (Cylinder 2 misfire), P2305 (misfire)
Fixes & Summaries for Chrysler
|2004 Chrysler Pacifica 3.5L hvac box VIN: 2C8GM68454
Asked the customer for check out time to investigate problem.Customer didnt want to pay diag.time.customer picked up the vehicle.Havent heard from cust.since
|2004 Dodge Caravan SE 2.4L MIL Lamp on VIN: 1D4GP25B34
Thank you very much guys. I got the vehicle back into the shop today and replaced both o2 sensors and the cat. I've given it 2 extended trips and the LT fuel trim has settled at -1% which I'm very ok with. No pending codes, good o2 readings: Looks like it's... Trouble codes: P0420.
|2007 Dodge Caliber SE 2.0L MIL Lamp on VIN: 1B3HB28B47
Thanks for all the replies. I talked to my local dealer and found out the vehicle had the TSB done on it. I took a chance and figured the low milage replacement motor may have not had it done. I took the vlaves and cam sensors out of the old motor and cleane... Trouble codes: P0017 (Crankshaft/Camshaft Timing Misalignment Bank 1 Sensor 2).
|2007 Dodge Ram 1500 Truck TRX4 4.7L dash cluster VIN: 1D7HU18N27
I found the fix almost by accaident. I was tracing wires, unplugging harnesses from back of fuse box under hood. Found the top harness corroded, several pins broken because if it. None of with went to any thing. cleaned others. has not been back so ill call it...
|2010 Dodge Journey SXT 3.5L MIL Lamp on VIN: 3D4PG5FV4A
Happy February everyone! Mine's a good deal brighter from the apparent fix that a rear bank catalytic converter (maniverter) had on my Journey. I've waited longer than iATN would like because only time proves any repair on this unit to be good or bad and we'... Trouble codes: P013A.
|2004 Jeep Liberty Limited 3.7L 4wd VIN: 1J4GL58K74
thanks for the help, didn't think there was an adjustment. customer chose not to incur the cost of replacing the cable ( that comes with the handle for 340.00 w/labor ) since her 4wd is working although the full time light does not come on.
|2005 Jeep Grand Cherokee Laredo 3.7L Oil Pressure light VIN: 1J4GR48K55
Replaced oil pressure switch and no further problems. It was not leaking. Replaced it with a oem sensor.