× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for January 16, 2013
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2002 Chrysler 300M 3.5L reverse VIN: 2C3HE66G02
Vehicle came in with complaints of reverse slipping- drive gears OK. Scanner pulled p0736 and p1790. I verified car has reverse and drives/shifts well but with a load in reverse, it will start to slip. Fluid is very clean albeit overfilled by 1 1/2 qts. I drai...
View
2000 Dodge Durango 5.9L pcm VIN: 1B4HR28Z7Y
Before installing the 3rd ecm I checked wires grounds and connectors.Replaced broken engine to body ground.I found what looks like 2 melted sockets/terminals in conn. c3 at the ecm.One goes to the overdrive switch which is a momentary ground switch and checks ...
View
2000 Dodge Ram 1500 Sport 5.9L Limp mode VIN: 3B7HC134XY
test passes in shop but cust drives 100 miles and codes and limp mode return
View
2002 Dodge Stratus ES 2.7L Timing Chain Tensioner VIN: 1B3EL56R12
Hello Fellow techs, I have a misfire on cylinder 5, we swapped the ignition coil and spark plug with cylinder #2 misfire didn't follow, replaced the fuel injector and same problem is there, checked compression and have good compression 160psi. Inspected cam an...
View
2004 Dodge Ram 2500 ST 5.7L 4 cyliders dead VIN: 3D7KU28D94
Hello to all again. We get the wierd one of the week award. A body shop we work with brought us this truck he was trying to help a car lot with. It has had the engine changed out from another truck. It runs real bad and on only 4 cylinders. Compresion is 150 a...
View
2004 Dodge Dakota Sport 4.7L odo says no bus VIN: 1D7HG38N34
Odo displays ( NO BUS ) 6 gauge dash none of the gauges work. Starts and runs well. Checked Power distribution battery lead in took apart cleaned and sealed with dielectric grease checked and cleaned all grounds both fender grounds and all firewall grounds all...
View
2008 Dodge Nitro SLT 3.7L heating system VIN: 1D8GU58K68
truck came in with low heat in cabin when turned right up to the max. warm air only. -could not find any tsb's relating to this. -lots of rusty sediments in antifreeze. -performed cooling system flush, back wash the heater core. -used cleaner conditioner when ...
View
2006 Jeep Grand Cherokee Laredo 3.7L Filling VIN: 1J4GR48K86
I have seen a TSB on this issue and have followed it to the end and found no issues. Any help would be appeciated from you jeep guys thank you in advance for your time.
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2003 Chrysler PT Cruiser GT 2.4L cluster display an all other lights VIN: 3C4FY78G23
Customer was suppose to bring the vehicle back. Didn't happen so I will update if this happens
9
2005 Dodge Grand Caravan SE Plus 3.8L ASD Relay VIN: 2D4GP44LX5
Thanks to all that replied. Many of you were right. The end result was a power loss between ign. switch start/run terminal and terminal 17 on connector 3 at back of IPM (integrated power module)pink/white wire. Fuel pump & ASD relays would close and we we woul...
11
2008 Dodge Ram 1500 ST 3.7L Misfire VIN: 1D7HA16K88
Thanks for all the info. Most were leaning toward valve or spring problems. I talked to customer and he will return to dealer with extended warranty. Thanks again Randy Trouble codes: P0304.
16
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next