|Prev||Professional Automotive Repair Technical Discussions for January 11, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|2002 Ford Taurus SE 3.0L Poor Idle Quality, Surge VIN: 1FAFP53U22
no codes customer complaint high idle and car running at speed like throttle sticking has had at another shop they replace idle air control valve i have checked grounds installed scan tool no codes car idles high at times and does pull itself at lower speeds t...
|2007 Ford Ranger FX4 4.0L transfer case VIN: 1FTZR45EX7
Vehicle came in with no reverse and slipping in first. Removed and rebuilt transmission. Now we have a very loud pop/bang type noise when driving over 40 mph in 4x4 high. Does not make this noise at low speeds or tight turns. Will not make this noise in 4x2. R...
Fixes & Summaries for Ford
|2000 Ford Escort ZX2 2.0L No Start VIN: 3FAKP1136Y
Sorry for my loss of words on the testing of the signal at the ECM and coil. I had signal at the coil and ECM for cylinders 2 and 3 but no signal for 1 and 4. I verified I had a circuit though the coil because it would show 12 volts key on engine off so I knew...
|2002 Ford Ranger XL 2.3L Charging VIN: 1FTYR10D32
The replies check the fuse for corrosion where dead on. Cleaned everything up and no more problems. Thanks for the help.
|2003 Ford E-350 7.3L No Start, MIL Lamp on, crankcase pressure VIN: 1FDWE35F23
thanks to everyone for your input. after checking fuel pressure,injectors,glow plugs,oil pressure,compression etc. and everything passed,the only other thing I could think of to check was the cam sensor it self. even though I was getting a good reading on the ... Trouble codes: P1670, P0603.
|2006 Ford Escape XLT 3.0L abs light on VIN: 1FMYU93116
Well the one came back today the escape and everything was fine with the light so I figuer it to be mossture but custumer said started to make noises so I check the toner rings and sure enough the r/f was broken thans for all the help
|2010 Ford Focus SE 2.0L Noise VIN: 1FAHP3FN6A
Just noticing that the oil was rather thick and saw that oem requires 5W20. We changed oil and that absolutely fixed the problem. Who would've figured?
|2011 Ford Ranger XL 2.3L Poor Idle Quality, Misfire VIN: 1FTKR1ED7B
Found if you wiggle the connector on the injector miss would come and go. Replaced injector connector and performed a repro on P.C.M. Thanks for all the great resposes. Trouble codes: P0201 (Injector Circuit Open fuel Injector 1), P0219, P0301 (Cylinder 1 Missfire Detected), P0316 (Missfire Detected On Startup).