 Prev |
Professional Automotive Repair Technical Discussions for January 7, 2013 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2001 Dodge Ram 1500 ST 5.9L 3-4 shift VIN: 1B7HF13Z11 looking for some clarity one this one. truck came in with a no shift, slipping concern. had gov pressure issues. replaced the gov sol and noticed some diebris on the screen. looked at the iatn fix data base and told cust that it should have a rebuild or reman ... |
View | |
| 1999 Jeep Grand Cherokee Laredo 4.0L temp sensor VIN: 1J4GW58SXX Jeep came in with a check engine light on (p1756) and trans started out in 2nd gear. Scan data showed no governor pressure. Diagnosed as bad pressure sensor. We replaced the governor pressure valve and the governor pressure sensor. Test drive and trans shifts ... |
View | |
| 2006 Jeep Liberty Sport 2.8L MAF sensor VIN: 1J4GL48546 Hello all, We have Jeep Liberty 2.8CRDI with problems. Customer brought the car with no acceleration and high fuel consumption, and MIL (code P0101, Mass Air Flow Sensor). During test drives we had strange air flow readings: at 3171rpm 136 g/s of air at 100F. ... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2007 Dodge Sprinter 2500 3.0L MIL Lamp on, Exhaust leak VIN: WD0PE74597 Thank you for the replies. We found two support brackets that were missing bolts on the engine block. The support brackets attach to the new egr tube retainers that were missing during the first repair. I was afraid that the local parts dealer would not cover ... Trouble codes: 2079 (Differential Pressure Sensor Engine Protection Active), P2623 (Charge air system drift at idle), P2626 (DPF soot content too high). |
5 | |
| 2003 Jeep Grand Cherokee Overland 4.7L Fuse #6 VIN: 1J8GW68J53 Thanks for the help. I also posted this in the Technical Theory Forum and Alvaro in Sunny Aruba actually nailed it. The customer had replaced the cylinder head gaskets and got it out of time. Evidently when that happens, the skewed cam signal causes too many c... |
9 |
