|Prev||Professional Automotive Repair Technical Discussions for December 22, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|1998 Honda Accord EX 3.0L upshiting VIN: 1HGCG1651W
This is my sons 98 Honda Accord, it starting flaring on upshifts, and even neutraling out at times. We replaced the A/B clutch pressure solenoids because there was a tsb which described the symptoms we had, still has the same problem, we cleared the codes, I k...
|2006 Honda Pilot EX 3.5L Poor Idle Quality VIN: 2HKYF18476
My tech recently replaced the front cylinder head and upon completion, the idle became erratic about 1 minute after start up. We are getting a PO507 IAC code. I have checked for vacuum leaks with propane and even starting fluid out of frustation. I removed the... Trouble codes: P0507
|2001 Infiniti QX4 3.5L dead battery VIN: JNRDR09X61
This vehicle has a 500 miliamp drain. The drain goes away when i unplug the 40amp fuse labeled (Fl40a BAT)The fuse is in the fuse box on the right side under the hood. From what i can see it feeds the body control module. I really dont know how to proceed with...
|1987 Subaru Justy GL 1.2L Runs Poorly VIN: JF1KA73A6H
Hi there everyone and thanks to anyone that can shed some light on this oldie subaru. I have this carbed 3 cylinder that was brought to me for running poorly especially under load. Low power, misfire and just in general a dog. Someone put a timing belt in it a...
|2005 Subaru Forester XT 2.5L Mechanical VIN: JF1SG69615
WE ARE ASKING FOR HELP TO DETERMINE THE CORRECT CYLINDER HEAD BOLT TIGHTENING SEQUENCE.ALL DATA HAS 2 DIFFERENT PROCEDURES,THE LAST STEP IS CONFLICTING.ALL DATA HAS(a)tighten to (22ft lbs).(b)tighten to (51 ft lbs).(C)back off bolts 180 degrees & 180 degrees a...
Fixes & Summaries for Asian
|2001 Honda CR-V EX 2.0L Stall VIN: JHLRD18611
replies where correct adjusted valves and problem did not reappear.customer has had car for 2weeks now . thanks for all the replies. W
|2008 Toyota Corolla S 1.8L MIL Lamp on VIN: 1NXBR32E98
The customer has not brought the car back so i can run the tests that were recomended. Trouble codes: P0101 (Maf sensor range performance).