 Prev |
Professional Automotive Repair Technical Discussions for November 22, 2012 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for GM
| Help Request | Answers | |
| 1997 Chevrolet Monte Carlo LS 3.1L ignition VIN: 2G1WW12M4V This car stopped here and would not start again. Sometimes it would start and run for about 30 seconds then die. The scanner shows no RPM when cranking except somtimes when it would start. Now it shows the 24X crank sensor as 163480. Both crank sensors are new... |
View | |
| 2005 Chevrolet Aveo LS 1.6L Poor Idle Quality, Surge, Misfire VIN: KL1TD52675 Mil lamp inoperative, random misfire code, cannot get data from ECU but can pull codes. ECU defective??? |
View |
Fixes & Summaries for GM
| Fix/Summary | Answers | |
| 1986 Chevrolet Camaro Z28 Iroc-Z 5.0L carburater VIN: 1G1FP87H3G Im fairly new when it comes to carbs but i went ahead and checked the voltage to the choke its at B+ with key on, i also wrapped the fuel lines, double checked the gaskets, all were sealing and finally adjusted the choke idle and mixture. the car starts fine ... |
33 | |
| 2006 Chevrolet Impala LS 3.5L Tcc VIN: 2G1WB58K56 Happy Thanksgiving all, After discussion with customer it was decided to go with a GM reman unit. I ordered the unit and let customer drive the car. Two days later trans quit pulling altogether. I will install the reman unit this week. Thanks again for all the... |
12 | |
| 2007 Chevrolet Impala LTZ 3.9L ABS module VIN: 2G1WU58R27 Since I cannot get the vehicle back before my posting expiration date times out I have to close out my request with a summary,but plan on posting repair when the job is completed. First of all I've recieved great responses from you guys that will let me look ... |
15 | |
| 2008 Chevrolet Malibu LT 3.6L Fusible Link Thanks for the help, I must say we were misled on this one. I went back to the car and did the continuity test myself, and there was no cont to ground on the generator's B+ terminal. Our next move was a waste of time. We removed the generator and took it ou... |
12 |
