|Prev||Professional Automotive Repair Technical Discussions for November 16, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2004 Chrysler Sebring Limited 3.0L engine VIN: 4C3AG52H54
engine has a vibration that is most noticable at idle through the steering wheel. The engine has a vibration at higher rpm that is not noticable when car is moving, only at idle. Crankshaft damper looks ok and the motor mount look ok. Have not been able to fin...
|2007 Chrysler 300 (Car) Limited 3.5L heater VIN: 2C3KA53G67
Hi guys. I have this 300 touring sitting for four days. It is a return on the previous tech before me. Issue is no heat in cabin. Performed chrysler diag. and found leak on pump. Replaced pump and found very small hole in radiator. Replaced these two parts and...
|2004 Dodge Ram 2500 Truck ST 5.9L left rear brake VIN: 1AMAT50714
first off: I'm not sure about VIN as it was given to me over two way radio from remote field shop. abs dash light on. found left rear drive axle brake super hot as it had been dragging. right brake not dragging and not hot -same as steer axle brakes. disassemb...
Fixes & Summaries for Chrysler
|2004 Chrysler Pacifica 3.5L starter intermittent VIN: 2C8GM68484
Everyone here was correct I think. Bad motor mounts ripped ground out of terminal just enough to.cause intermittent problems. Replaced ground cable took. advice and relocated new ground to bell housing. Fixed. Thanks again to.all that helped.out!
|2005 Jeep Grand Cherokee Laredo 3.7L no crank VIN: 1J8GR48KX5
thanks everbody for the info yellow wire connecter was crodded replaced connector will have to see what happens ill let yall know thanks again jimmy