|Prev||Professional Automotive Repair Technical Discussions for November 6, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2002 Chrysler Town & Country (Van) LXi 3.3L hard start VIN: 2C4GP44342
I have a 2002 town and country here that starts hard in the morning, like you have to clear flood it to get it going. Once it starts up it is fine all day long. I first thought fuel pressure was dropping and it had to prime the fuel system befor it started, bu...
|2007 Chrysler Pacifica Touring 4.0L No Start VIN: 2A8GF68XX7
We had this vehicle towed in as a no start. upon cranking it sounded like it had skipped time or had a mechanical issue. We pulled a relative compression test with our oscilliscope and it showed one bank had low compression. we then hooked up to the pcm to pul...
|2002 Dodge Grand Caravan Sport 3.3L Mechanical VIN: 2B4GP44372
rear cylinder head gasket is leaking again added dye to make sure were its coming from. is it possible to get the wrong gasket on the wrong side? We dont do a lot of these Thanks for any help Scott
|2009 Jeep Wrangler Unlimited Sahara 3.8L Poor Idle Quality, MIL Lamp on VIN: 1J4GA59189
The owner brings this one in for a grinding noise at cold start ups and the check engine lamp is flashing. The vehicle is running rough. I look at the misfire monitor and it is all over the place. There is no consistent cylinder misfiring. Sometimes five cylin... Trouble codes: P0300
Fixes & Summaries for Chrysler
|1999 Jeep Grand Cherokee Laredo 4.0L transmission VIN: 1J45YTDKNY
well thanx to all for the responses,whe decided to send transmission out to get rebuild, agter tring just about everything from fluid exchanges to valve body replacements, etra flui coolers etc. i guess it was just too worn out. got a compleate rebuild an all ...