 Prev |
Professional Automotive Repair Technical Discussions for October 19, 2012 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2003 Chrysler Town & Country LX 3.3L Sentry, Power Control Module, Body control Module VIN: 2C4GP44353 Car came in for an intermittent No Start. Found the PCM (Power Control Module, sometimes referred to as the ECM) to not be sending out a start signal when turning the key to start. I then replaced the PCM with a used one. Both original and replacement have the... |
View | |
| 2006 Chrysler PT Cruiser 2.4L Lights, Battery VIN: 3A4FY48B56 Owner complaint: dead battery, lights and turn signals not working occasionally. Tested battery and parasitic drain... both fine. Could not confirm any lighting problem. Returned within a week with same problem. Again nothing found. Finally problem occured aga... |
View | |
| 2010 Chrysler Town & Country Touring 3.8L Dirt VIN: 2A4RR5D15A Customer complains of dusty vehicle when driving on gravel roads. Checked for cabin filter and chryler has eliminated it in the new body. Checked with chrysler and have no answer for me. Has any one else had this problem or a solution to this headache??? any i... |
View | |
| 2002 Dodge Caravan SE 3.3L no start VIN: 1B4GP25R82 I have been working on this one for two weeks now. When cold it will not start if it warms up it will start. No communication with inside modules mic,bcm,hvac. Once it is started it will be fine all day till it cools of like over night. No codes in pcm,tcm,bcm... |
View | |
| 2004 Dodge Ram 1500 ST 5.7L Left Low Beam VIN: 1D7HA18D54 This vehicle came with the left low beam not working. Customer had used 3 new bulbs and still no low beam on the left side. I disconnected the C7 FCM connector and tested for voltage at all the low and high beam pins. I have battery voltage at all the pins. As... |
View | |
| 1993 Eagle Talon DL 1.8L Starting VIN: 4E3CF34BXP i push the clutch inn , and turn the ignition switch , the insrtrment panel lights up but the vehicle is not starting , what could cause this? |
View | |
| 1999 Jeep Grand Cherokee Laredo 4.0L transmission VIN: 1J45YTDKNY Noticed transmission whent in to limp in mode, take of in second gear, i got the code for wrong governor prassure. After various testing, i replaced both transducer and sensor for governor, i noticed the fluid was very hot after 20min. of driving and kind of b... |
View | |
| 2005 Jeep Grand Cherokee Limited 5.7L No Start VIN: 1J8HR58265 This vehicle cam in a a tow truck as a cranks but no start, of course when it got to my shop it started and runs perfect. Apparently it has had multiple no starts but very intermittent previously it always started eventually but this time it wouldn't even afte... |
View | |
| 1970 Plymouth Barracuda 7.2L Carbs VIN: BH23G0B256 This is a old school help request, Thank in advance. This car (clone 1970s 440 6 pack) came to me on tow truck. The customer and my brother did some work to it before it got to me. It had been sitting for about 20 year and had ran great before sitting. My brot... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2001 Chrysler PT Cruiser 2.4L crankshaft VIN: 3C4FY4BB31 It seems by all of the replies I wasnt the only one to have a main bearing problem, We replaced all main bearings , replaced timing belt and front seal from dealer. Thanks alot Mark |
21 | |
| 1998 Dodge Ram 3500 5.9L no right front brake and now rear brakes. VIN: 3B6MC3664W UPDATE: i have not fixed this problem yet! i have bleed the brakes at the; master cyl(good pressure), abs unit(good pressure), each frt caliper(good pressure), at rear splitter block(no pressure),rear brake block next to linkage on frame(no pressure). block on... |
12 | |
| 1999 Dodge Ram 2500 5.9L Seat Belt Retractor Solenoids VIN: 1B7KF2362X On a subsequent visit to this vehicle, I found the owner had removed a fuse that I missed. His reason for removing was to kill the chime. I did install a relay in the harness at the integrated electronic module (IEM) to isolate the left door switch circuit fro... |
3 | |
| 2003 Jeep Grand Cherokee Limited 4.7L heat VIN: 1J4GW58J13 THANK FOR ALL THE REPLYS. MATTHEW FROM MINNESOTA AND DAVE FROM ILLINOIS AND BARRY FROM VIRGINIA .WAS RIHGT ON WITH THE FIX WITH OUT PULL THE DASH OR HEATER BOX DEALER HAD A T.S.B FOR REPLACING BLEND DOOR IN THE JEEP IT TOOK ME 4hr TO DO IT WAS A LIFE SAVER THA... |
20 |
