 Prev |
Professional Automotive Repair Technical Discussions for August 24, 2012 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2005 Ford Explorer XLT 4.0L cylinder head VIN: 1FMZU73K45 Customer said car started idling roughly, just after church. He got home, and next day drove to another shop. Shop said it needed an engine, as the engine was locked up. He towed it to his house and asked for help on line. We turned the engine backwards and it... |
View | |
| 2011 Ford Edge SEL 3.5L Srs light VIN: 2FMDK3JCXB This car was in a front collision and I replaced driver air bag, clockspring, front sensors and driver seat belt. I test with scanner and all is fine and no trouble code but I still have an orange or yellow light of air bag at dash. How do I reset this light. ... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 1997 Ford Taurus LX 3.0L Misfire, MIL Lamp on VIN: 1FALP53S3V well,i feel like a total idiot...rhett,you nailed it. i know i double checked my plug wire routing but i had 5 and 6 switched. thanks to all the valuble help and ideas. lesson learned...dont over think a problem. Trouble codes: P0155 (B2S1 o2 heater circuit), P0161 (B2S2 o2 heater circuit), P0305 (cyl. 5 misfire), P0306 (cyl 6 misfire). |
18 | |
| 2001 Ford Expedition XLT 5.4L Misfire This one is fixed. I disconnected the pcm connector and the Inj. connector and hooked my headlamp test light across the power and control circuits. the power side of the connector failed with the load on it. I replaced the inj. connector tested it again and it... Trouble codes: P0304. |
15 | |
| 2002 Ford Explorer XLT 4.0L Transfer case VIN: 1FMDU73E92 Thanks to everyone who replied. The module did indeed take care of this problem. Thanks again. |
10 | |
| 2006 Ford Focus ZX4 2.0L installation VIN: 1FAFP34N96 Rob from British Columbia was right. The tool is 205-370 or t97p-1175-a. It will pull axle in,also the bearing was in backwards.I only sand and polish rust and grime off, not metal.I also make sure I press the out side of bearing into spindle then hold center ... |
5 | |
| 2008 Mercury Sable 3.5L Strut? VIN: 1MEHM40W38 New left strut took care of the noise. Apparently the part number has changed three times already. It comes with a new bumper and the threaded rod end of the piston is actually longer than the original (a new nut is needed as well). Thanks for the replies and ... |
6 |
