Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for July 27, 2012
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1998 Ford Ranger Splash 2.5L check gauge light VIN: 1FTYR10C1W
Hello all and thanks in advance for any help I have a 1998 Ford ranger with a 2.5 and a stick that has a "CHECK GAUGE" light coming on when it hits roughly 2200 rpm, any lower the light goes off and any higher the light goes off. The rest of the gauges all rea...
View
2001 Ford Taurus SE 3.0L Poor Idle Quality VIN: 1FAFP53U81
Idles high. What happens is it idles high at [...] for extended period when started warm. After 20 seconds, idle goes down to 700rpm. Same thing when you rev it in park, idles high then slowly lowers. What i've done; Checked code p1506 pending, not hard an... Trouble codes: P1506
View
2006 Ford E-450 Super Duty 6.0L solenoid a VIN: 1FDXE45P06
hello, and thanks for any help in advance.inherited this bus from trans shop.came in w/multiple trans codes,and was in "limp" mode. codes were cleared,and the only one to return is p0750, soleniod "a" ckt problem/open ckt.i have checked wiring from pcm to the ...
View
2010 Ford E-350 Super Duty XL 6.0L Hesitation VIN: 1FDXE4FP1A
thanks for help in advance. just have a pretty simple question relating to the block heater on a 6.0l diesel. this vehicle is an ambulance and runs great except for the first 2 or 3 munutes after initial cold startup. with vehicle plugged in all night it exibi...
View
2001 Lincoln LS 3.0L passenger side rear door VIN: 1LNHM86S11
just had this car brought to me (i normally don't work on cars). Problem is the door latch, or cable is broke on the passenger side rear door, and I cannot open it. Is there a way to remove the panel with the door closed? Or another way to open it (i,e sacrifi...
View
2005 Lincoln Town Car Signature 4.6L System Pressure VIN: 1LNHM81W85
Fellas I almost hate to post this, but I'm missing something here. Father in-laws car. I have been over this thing with a fine-toothed-comb several times and cannot find a dye trace or sniff out a leak. Every connection, switch, line, component, etc. System on...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1994 Ford Ranger STX 3.0L No Start VIN: 1FTCR15U4R
Not having the PIP signal should have been enough for me to pull the trigger on this distributor but I wanted to check all possibilities first. I installed a distributor in this truck this morning and the PIP signal returned. This truck came to me with a re...
8
2007 Ford Edge SEL 3.5L ABS/Brakes VIN: 2FMDK39CX7
The tip from Patrick about pressure bleeding and pumping the pedal with pressure on the system was the winning tip! Thanks VERY much! We did finally get the last of the air out from the right rear, and now have a good pedal!
2
2007 Ford Fusion SEL 3.0L Hesitation, Stall VIN: 3FAHP02107
thanks to all who suggested timming chain bank 2 timming had jumped 2 teeth never would have believed it with the compression readings ,realy appreciate everyone who took interest and replied ps this thing is a bear to teardown chris Trouble codes: P2273.
11
2011 Ford F-250 Super Duty XL 6.2L Mechanical VIN: 1FT7X2B63B
Customer installed a k&n air filter in the spring, this truck sees 3000 miles of dirt roads every two weeks. The intake was full of dust and dust deposits after the air filter! Looks like oil must be getting past rings, just suprised with that much consumpti...
7
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next