|Prev||Professional Automotive Repair Technical Discussions for June 17, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|2000 Isuzu N NPR-HD 4.8L Poor Fuel Economy, diminished power VIN: JALB4B147Y
This truck runs great but, does not have the power that it used to have and its mileage has decreased by about 2 mpg. I can't communicate with it with my scanner. There is no check engine light on. I'm not sure what to look at or where to turn. Please help.
|1991 Mazda RX-7 1.3L Excessive Emissions VIN: JM1FC3316M
Hello RX-7 specialists. I have this old but low mile RX-7 that failed our IM 240 test. On first test the CO was 44 grams per mile, more than double the 20 GPM limit. I don't know alot about rotary engine cars, so I took it down to the emission technical center...
|2007 Nissan Sentra SL 2.0L No Start VIN: VY11304587
Hi guys This car is actually a 1999 nissan sentra with a QG 15 engine. IATN did not give me that option. This car came in with P0335. Changed sensors both cam and crank sensor. The crank sensor code remained. A new engine harness was installed but the real pro...
|1992 Toyota Pickup 3.0L Misfire, MIL Lamp on VIN: JT4VN82N0N
Have an intermittent code 12 (loss of rpm signal to ecu) truck will run rough when the ecu sees this problem...need help please Trouble codes: 12 (Loss of rpm signal to ecu)
|2006 Toyota Sequoia Limited 4.7L Cuts out, Stall, MIL Lamp on
Truck was towed in wouldnt start.Upon inspection.It will start sputter for a 15 to 30 seconds and stall.Smelling as though it was running very rich I tried to throttle it up(drive by wire)and realized I have no throttle action.prolly why it smells richs.I chec...
Fixes & Summaries for Asian
|2002 Honda Civic Si 2.0L MIL Lamp on VIN: SHHEP33542
Thanks for every ones response on this. I found that the vtec oil psi switch wasn't connected. The old vtec valve did not have a pressure switch in it, it had a plug in its place and the wire connector was taped up in the wire harness.When I took the new vtec ... Trouble codes: P1259 (Vtec system fault).