|Prev||Professional Automotive Repair Technical Discussions for May 26, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for GM
|1990 Cadillac Seville 4.5L MIL Lamp on VIN: 1G6KS5333L
Greetings to all my fellow lunatics who have chosen automotive repair as a profession. This wonderful vehicle came to me misfiring on 4 cylinders. Found blown fuse for fuel injectors. Tested injuctors and 3 out of 8 were shorted. Replaced all 8 injectors only ... Trouble codes: E052 (ECM memory reset)
|2004 Chevrolet Silverado 1500 5.3L Unknown VIN: 1GCEC19T94
please help. follow all data instruction did not help. please advice how to check this DTC P2797 Auxiliary Transmission Fluid Pump Performance clear mil and drive 2 mile, mil turn on code p2797. thanks
|2006 Chevrolet Tahoe Z71 5.3L No Start VIN: 1GNEK13T76
Vehicle came in for flames coming out of exhaust. Runs rough and hard shifts. Hooked up tech2 and scan for dtc's p0300 and p0455. Went to misfire graphics on tech2 and showed misf. On all cyclinders. Tested each injector and flow was at 105kpa at all injectors...
|2008 Pontiac G6 2.4L Several computers VIN: 1G2ZF57B58
Ok here it is. This car will run great for the first 10 min with no problems or anything, also no codes. After that (if the A/C is on it will always act up sooner) the TCS light comes on the CEL comes on, the A/C compressor short cycles, the radio reads "power...
Fixes & Summaries for GM
|1996 Chevrolet Impala SS 5.7L MIL Lamp on VIN: 1G1BL52P5T
Hi there, this impala is finally fixed, I got four helpful responses, however chuck was right about using the original distributor. we installed a reman. (from gm dealer) no new ones available, and it took care of the problem, no codes set any more, vehicle is... Trouble codes: P0372, P0336.
|1997 Chevrolet K1500 4.3L No Start, Poor Idle Quality, Stall, Misfire
thank you for all of your replies. first of all sorry for the delay customer asked me to wait a few days so he could think about his investment. yesterday morning he gave me the [[[go ahead]]] so first thing i did was to pull the distributor just to make sur... Trouble codes: P0108.