 Prev |
Professional Automotive Repair Technical Discussions for May 23, 2012 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2003 Ford Mustang 3.8L power top VIN: 1FAFP44453 Hello Einsteins: I am hopeing someone out there has run into this before, I have a 03 mustang came in with power top not working, pump motor runs ok traced to bad pump, installed new ford pump and used recomended fluid. Top started to go up and then I heard a ... |
View | |
| 2005 Ford Explorer XLT 4.6L Lt Rear VIN: 1FMDU73W25 Vehicle arrived with leaking left rear valve stem. Seal in the tire monitor was bad. Ordered new and replaced and attempted retraining process per Ford. All wheels will acknowledge the training procedure except the one with the new monitor. Replaced with diffe... |
View | |
| 2005 Ford F-150 FX4 5.4L lights,radio,locks VIN: 1FTPW14555 Hi there I have this pickup here that when you open the doors the radio does not shut off the key does not chime and the dome lights do not come on. The door locks, key pad and key fob does not work also. I've checked all fuses and relays that I see go with th... |
View | |
| 2006 Ford Ranger XLT 3.0L Poor Idle Quality VIN: 1FTYR14U16 I hope someone can help me with this thing so I can leave for my fishing trip on time. OK this thing has a rough idle some times worse than other times but definately not smooth if you watch fuel trims they are a little higher on the left bank 11 and rt bank 0... |
View | |
| 2007 Ford Focus SES 2.0L No Start, Cuts out, Stall, MIL Lamp on VIN: 1FAFP31N97 Can watch the pids on computer to see that it is turning fuel pump on and is duty cycle at 44.9 % but isn't getting desired fuel pressure from pump..Can shut key off and start it right back up and everything is perfect with pressures...also the computer shows ... Trouble codes: P0191, P1233 |
View | |
| 2008 Ford F-350 Super Duty XLT 6.4L Clutch pedal VIN: 1FTWF31R28 Hey folks have a funny one,The clutch peddel will stay on the floor on a higher rpm shift (Approx 3000).You can pick up the pedal with your toe and the clutch will work just fine untill you hammer on it again.We have already replace the clutch slave and master... |
View | |
| 2008 Ford Expedition XLT 5.4L lacks power on accel VIN: 1FMFU16568 After performing listed repairs, vehicle still has no "top end" acceleration. Can only get up to 70mph and feels like restricted exhaust would feel. No codes, O2 data does not suggest cat failure. Lack of power happened instantly for customer when active YAW c... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 1994 Ford E-350 Econoline 7.5L Poor Idle Quality, Surge, Cuts out, Stall VIN: 1FDKE30G2R found pcm getting hot cutting out fuel pump and pcm relays swapped out pcm veh runs fine waiting on pcm repairs Trouble codes: 624. |
8 | |
| 2003 Ford Expedition XLT 5.4L Misfire, MIL Lamp on VIN: 1FMFU15L73 i did some further diag on this thing stft 1 (0) stft 2 (4) ltft 1 (3) ltft 2 (-3) fuel koeo 50psi koer 55 under load 55 current ramped pump=good. fuel volume good. i did remove filter due to some debris in fuel during volume test. was very dirty so i repla... Trouble codes: P0316, P0303. |
17 | |
| 2005 Ford F-550 Super Duty Lariat 6.0L no oil pressure VIN: 1FDAF57P45 Thanks for everybodies help, this truck was a nightmare,The fix was a combination of several problems,the oil tube under the intake coming from the high presure pump had a crack in it, and the oil tube in the head had bad o-rings replace tubes and head gaskets... |
14 | |
| 2006 Ford Freestyle SEL 3.0L No Start, Poor Idle Quality VIN: 1FMZK02136 Thank you to all who replied to the help request. First of all, yes it was covered by the 8/80 warranty but the customer did not want to return to the dealer for repair. Second, thanks to all suggesting smoking the intake manifold. What I found was an upper in... |
10 |
