|Prev||Professional Automotive Repair Technical Discussions for April 12, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2001 Chrysler Town & Country (Van) LXi 3.3L Dash display VIN: 2C4GP54321
Good afternoon Customer replaced battery and as he installed cables he noticed some smoke from the starter area, of course he says the terminals were not crossed. Anyway he also replaced starter and installed a different battery. Starts and runs fine, no HVAC...
|1997 Jeep Grand Cherokee Limited 4.0L No Start, Hesitation, Cuts out, Stall, Misfire, MIL Lamp on VIN: 1J4GZ78SXV
[...] Trouble codes: P0351 (Ignition control circuit)
|2004 Jeep Liberty Sport 2.4L Blend Door VIN: 1J4FK48174
Vehicle came in for no cold air out of vents (100 Degrees). AC compressor cycles normally, hooked up gauges and pressures look normal - 175psi High and 10psi Low. First thought that came to mind was to check blend door operation, Identifix said to check wires ...
Fixes & Summaries for Chrysler
|1996 Dodge Ram 1500 Truck 3.9L No Start VIN: 1B7HC16X2T
Thanks for all the replies. As always the responses were great and covered a variety of possibilities. Chris, Brad, and Don hit it on the head with this one. Initially I must have missed that communication was reestablished with the 5v reference circuits unplu...
|2004 Dodge Grand Caravan SE 3.3L Left rear wheel speed sensor VIN: 1D4GP24RX4
Thank for advice customer did not want to replace sensor but next time I get this complaint for this vehicle I will check ground abs wire on smallest volt scale on scope