|Prev||Professional Automotive Repair Technical Discussions for March 18, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for GM
|1989 Chevrolet Corvette 5.7L speedo tach VIN: 1G1YY2186K
digital speedometer n tachometer r inop,took dash out n looks good behind board,nothing burned,grounds were not attached properly,put back n still inop,scanner will not communicate.goin to take pcm out n look at numbers.motor runs good,noticed speedo gear on s...
|2003 Chevrolet Impala 3.4L hi/low beam VIN: 2G1WF52E83
Can the hi/low beam switch be replaced in the turn signal module? The dealer wants $500 for this module. I've removed the module and taken the switch out, cleaned and reinstalled and it worked for a while, but returns to not clicking the hi beams on when actua...
|2004 Chevrolet Malibu 2.2L Cooling fan
Hi everyone have this 2004 malibue classic with 2.2 4 cyl eng, radiator fan motor will not come on, temprature gauge works fine, i can control the fan with scanner they will come on when i command them,also the pid for ect goes up on scanner fine, i replace th...
|2005 Chevrolet Classic (Car) 2.2L No Start
Howdy everyone. This is my personal vehicle that has me baffled. It is a 2005 Chevy Classic (not Malibu) that will not start. The Theft System light is not flashing (tried the 10-15 minute wait to start and nothing) and while cranking the Theft System light go...
Fixes & Summaries for GM
|2010 Chevrolet HHR LS Panel 2.2L abs/trac warning light/message VIN: 3GNBAADB8A
well, i was unable to finish checking this one. the real problem was that i could never duplicate it in the shop. the only was way i could reproduce the code was by unplugging the sensor, so i figured we had a break in the harness somewhere, from the strut in...
|1993 GMC K1500 Suburban SLE 5.7L neutral switch VIN: 1GKFK16K2P
We cut purple wire from ignition switch & ran a new wire to the neutral switch & then another wire from neutral to starter,,The only puzzling thing is that a purple wire 10 guage is at the ignition switch & at the starter but the wires that were at the neutral...