P0341 Diagnostic Trouble Code Discussion for February 2012
CMP Sensor Performance
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0341
| Help Request | Posted | |
| 1995 Buick LeSabre Limited 3.8L Poor Idle Quality, Hesitation, Cuts out, Stall, MIL Lamp on VIN: 1G4HR52L4S P0341: cam/crank error. this vehicle continually sets code P0341, I've gone through the flow charts for code 341 and 342 with no help. I believe that I [...] have something in common and someone else has run across a similar problem. Thanks in advance for your help. |
February 09, 2012 | |
| 1995 Buick LeSabre Limited 3.8L Poor Idle Quality, Hesitation, Cuts out, Stall, MIL Lamp on VIN: 1G4HR52L4S P0341: cam/crank error. this vehicle continually sets code P0341, I've gone through the flow charts for code 341 and 342 with no help. I believe that I [...] have something in common and someone else has run across a similar problem. Thanks in advance for your help. |
February 10, 2012 | |
| 1994 Buick LeSabre Custom 3.8L Poor Idle Quality, MIL Lamp on VIN: 1G4HP52L7R P0341: cam/crank error. I followed flow chart for checking wires to cam crank sensor and all tests good. Have scoped all sensors and all ok, well initially found crank and ignition control module to glitch which is why I replaced it. Runs rough at idle, sometimes worse then others. S... |
February 16, 2012 | |
| 1998 Volkswagen Jetta Wolfsburg Edition 2.0L MIL Lamp on P0341: cam signal not applicable. This car has 10.34 volts @ the #2 pin were it should have 5v reference? I've checked for shorted wires none found .removed pin 44 @ pcm green/white and i've got 10+ volts @ pcm. tried another pcm same thing!Has any of you vw techs seen this before? |
February 17, 2012 |
