Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for February 28, 2012
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2002 Chrysler Town & Country (Van) LXi 3.3L rear latch/actuator VIN: 2C4GP44342
This van came in, with the rear hatch would start going off, like someone was pulling the handle (Latch switch). It would pop open, and then it keeps trying to open rapidly. (NOTE: THIS IS NOT ELECTRIC LIFT GATE, MANUAL) So I pulled a body code,(Sorry I doní...
View
2007 Chrysler Sebring Touring 2.7L p/s pump rack pinion VIN: 1C3LC56R37
I have some problem with this vehicle. This vehicle came with hard steering and some noise. The noise itís not constant. The pump is working. We think that maybe the rack & pinion itís defective. We replace the power steering pump and the problem continues. We...
View
2009 Chrysler Sebring LX 2.4L intake manifold VIN: 1C3LC46B09
Hello everybody first time user of this site and very excited about the possible help I can give and receive. I have a code p2004 on this sebring and can not seem to find any info about it on all data except what it is. I removed the intake runner motor and tr...
View
2007 Dodge Sprinter 3500 3.0L MIL Lamp on, slight lack of power VIN: WDXPF44537
Hey guys, I do not have much experience on these Sprinter vans but the P0101 code has returned 3 times after clearing. The local dealer says that they are not having Air Flow Sensor problems. Does any one have any experience with this code and fix? Thanks for ... Trouble codes: P0101 (Mass air flow performance)
View
2002 Jeep Grand Cherokee Laredo 4.0L noise VIN: 1J4GW48SX2
It seems that this car has a clicking, and or whiring noise coming from the center of the dash either when braking and or when the front suspension is loaded up, when on the lift we can only get it to hapen when in 4x4 and if we remove the front drive shaft it...
View
2004 Jeep Grand Cherokee Laredo 4.0L power windows VIN: 1J4GX48S34
There is very little info. in alldata on this system. Alldata says to diagnose this system like anyother window switch w/o a data link. So I did the normal testing, ran the windows up and down by by-passing the switch,all windows worked fine. The diag. chart i...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2000 Dodge Intrepid 2.7L MIL Lamp on VIN: 2C3HH46R0Y
It's been about 3 weeks now since I last saw the car. Last time in,I looked at the map sensor and found it dripping in oil? I cleaned the sensor and cleared the code and the light has been off since then. I haven't done any checking to know where the oil is co... Trouble codes: P0172, P0175.
14
2004 Dodge Dakota 3.7L Unknown VIN: 1D7HG12K44
found a broken tapered snap ring in the low reverse reaction plate, also suprisingly, found od clutchs burnt. the fluid was clean, nothing really in the pan at all. I guess the key is looking at CVI numbers. now od is at 120, and the rest are between 35-38. (t...
12
2006 Dodge Ram 1500 Truck ST 4.7L transfer case VIN: 1D7HU18N56
TIPM AND SHIFT MOTOR WAS THE CURE. THEY WERE REPLACED AT THE SAME TIME AND THE FOUR WHEEL DRIVE WORKED AS IT SHOULD. THANKS GUYS
3
2007 Dodge Ram 3500 Truck ST 5.9L Misfire, MIL Lamp on VIN: 3D3MX48C17
Thanks to all of the helpful replies. I did not test the intake heater because I did find & repair the code & running problem. the heater worked fine and did not cause any problems once I replaced an injector. It so happened one time that the engine ran poorly... Trouble codes: P0204 (Inj 4 open), P0304 (4 misfire), P2149 (Group 2 voltate low/open).
5
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next