|Prev||Professional Automotive Repair Technical Discussions for December 25, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for All Makes and Models
|2005 Nissan Sentra S 1.8L No Start, Stall
car would not run right or start at times. I checked found code for p0340 so I replaced cam sensor with world pack sensor and it would not start. went to dealer got both cam and crank sensors put them in no start. put original cam sensor back in it starts runs... Trouble codes: P0340 (camshaft performance bank 1)
Fixes & Summaries for All Makes and Models
|1998 Buick LeSabre Custom 3.8L Airbags VIN: 1G4HP52K8W
Replaced clockspring and SDM module. Prior to connecting battery cables, double checked the two circuits from SDM connector to clockspring connector. Checked circuits for open, short to ground, short to power, and short to any other circuits in the SDM harness...
|2005 Jeep Liberty Limited 3.7L Starting
update and fix the bcm had fixed this liberty pci bus gateway through bcm to can to pcm was getting corrupt in the bcm replaced bcm and no more problems thanks for the replies
|2005 Mazda 6 i 2.3L Surge, MIL Lamp on VIN: 1YVHP80CX5
The problem was the purge valve which was an intermittent problem. After replacing the valve,long term fuel trims dropped down to near 0. The 02 had me somewhat confused with the heater switching on and off continiously,found out that was normal. I did smoke ... Trouble codes: P2187, P2195.