 Prev |
Professional Automotive Repair Technical Discussions for December 17, 2011 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2002 Ford Escape XLT 3.0L No Start Hey all having some touble with a PATS system. This car has been a problem child for a while now. Vehicle came in about two months ago with a no crank no start and the Theft light was flashing. Pulled codes for the security system with the Ford IDS scan tool a... |
View | |
| 2006 Ford Escape Hybrid 2.3L Inverter & Generator VIN: 1FMYU95H06 After 30-40 mins. of freeway driving,(freeway only, moderate speeds are OK) 65 mph (unable to duplicate but happened to customer twice) vehicle shuts down and the following codes are set: P0A3C-Drive motor A inverter over temp. P0A3E- Generator inverter over t... |
View | |
| 2009 Ford F-350 Super Duty XLT 6.4L Misfire truck has an intermittent missfire on cylinder 2.Setting codes 0302 and 0226 .Both are clinder 2 missfire codes.replaced injector and tube with oe.same problem.not setting any codes for injector circuit.tried wiggling the harness at pcm and where it enters val... Trouble codes: 0226 (cylinder balance /contribution cly2), 0302 (cyl 2 missfire) |
View | |
| 1999 Lincoln Town Car Signature 4.6L Drivers side air bag code VIN: 1LNHM82WXX I do not do much air bag work, so before I get to involved in testing I thought I would put this out. I am going to R&R the front seat and air bag module and test the wiring to the drivers seat according to the wiring system. I suspect I will find a broken wir... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2004 Ford Explorer NBX 4.0L MIL Lamp on VIN: 1FMZU73K64 We did a good basic maitenance tune up, R/R plugs and wires, cleaned throttle body, serviced battery. Pin point tested for fault P0108. After Checking all the grounds checking and rechecking continuity in the harness and doing a wiggle test that showed nothin... Trouble codes: P0108 (Map), P1116 (Ect). |
6 |
