× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for November 25, 2011
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1997 Ford Expedition Eddie Bauer 5.4L Misfire, MIL Lamp on VIN: 1FMFU18LXV
We did a tune up and filter change the truck ran a lot better but failed the emission test. with the scan tool we got a misfire in # 5 cly. we changed the coil and tested it again and it ran perfect until it heats up and then it will start with the miss again.... Trouble codes: P0305
View
1998 Ford Ranger Splash 4.0L Misfire VIN: 1FTYR11X6W
we have a weird one here. cyl no.3 misfire,cyl contribution test shows negative numbers in the 20's. tested compression all ok. Tested injectors all ok.pulled lower intake and found the runners for cyl. 3 very clean. the rest had carbon build up etc.i noticed ... Trouble codes: P0303
View
1998 Ford F-150 Lariat 4.6L No Start, Poor Idle Quality, Hesitation, Surge VIN: 1FTZX17WXW
thanks in advance to all who replied. well vehicle came to me running fine,failed emissions, chk eng light on, po171,174,and 131. smoked test showed intakes leaking,st trim 0 lt trim 35.replaced intakes,fuel filter, and right upstream o2,also plugs.since doing...
View
2005 Ford Five Hundred SEL 3.0L oil pressure VIN: 1FAFP24165
Well Its a holiday weekend so of course we have a problem vehicle. Ford came in for an oil change and a tune up. Did the work, test drove, and parked the car. After sitting for and hour or so, when the vehicle was started - the low oil pressure message + lite ...
View
2005 Ford Escape Hybrid 2.3L Stall VIN: 1FMCU95H95
This vehicle will run about 10min then the red triangle light for the hybrid warning comes on,, i get this codes p0a27,p1a10 at ecm and b1342 at the bcm .. The only way i can get vehicle back on is by disconecting the 12v battery for about 5min... Then it will... Trouble codes: P0A27, B1342 (Faulty control module), P1A10
View

Fixes & Summaries for Ford
Fix/Summary Answers
2004 Ford Freestar SES 3.9L MIL Lamp on VIN: 2FMZA57614
Most of you said replace the unit if I had exhaust and vacuum under it, as everything checked out I've took the advice and ordered it. Thanks to all that replied, some very good information sent, again thanks for sharing! Trouble codes: P0401 (insufficient flow EGR).
22
2006 Ford Five Hundred Limited 3.0L stumble VIN: 1FAFP28156
well i think this one is fixed. has been a week now and customer has not called back, no news is good news. took a shot and put a coolant sensor in this car because readings were always 20 and deg colder than act temp. strange thing is air temp read the same. ...
4
2010 Ford fusion 3.0L Steering VIN: 3FAHP0HG9A
snap on scaner would not relearn steering angle sensor I was able to relearn it with the ids
9
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next