× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for November 4, 2011
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2005 Chrysler Crossfire 3.2L no start/no crank VIN: 1C3AN65LX5
This 05 Crossfire come in as a no start/no crank.Battery was dead,replaced and still no crank.Scanned for codes and found 2071-08 which is SKREEM module is not sending signal to PCM.Also code 1040 for the Insturment Cluster no can to PCM.Have replaced the K4 r...
View
1985 Dodge D350 5.9L clutch rod VIN: 1B7MD36W1F
We recently replaced the engine mounts, transmission mount and the manual transmission assembly. After repair, the clutch linkage rod located at the transmission broke. Due to age we replaced the rod, bushings, bearings, and the "z-bar". Since then the Z bar h...
View
1998 Dodge Neon Sport 2.0L heater
Customer complaint of no heat, found that there is no flow of coolant from heater outlet and inlet pipes, installed clear section of hose to check.Also no flow at water outlet even with t-stat removed. Acts like water pump impeller is not turning or has damage...
View
2001 Dodge Ram 1500 Laramie 5.9L No Start VIN: 3B7HF13Z01
Hi all yesterday came in no start no power to injectors no bus message on dash found loose harness in PDC tightened and test drove over bumpy road no problem. try to start this morning would start and die remove harness from PDC and tighten again now wont sta... Trouble codes: P1687
View
2006 Dodge Ram 2500 SLT 5.9L AC compressor VIN: 1D7KS28C76
Shop truck for boat delivery; started truck, AC not blowing cold; shut off AC & engine; restarted & pushed AC button, blowing cold. Used truck, shut off, AC hasn't worked since. Compressor engages briefly, then releases; no DTCs. Our auto repair shop diagnosed...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2005 Chrysler Crossfire 3.2L MIL Lamp on VIN: 1C3AN65L65
Thanks for th insight. Did follow through on some suggestions although the concern all along was our mistake. We used a aftermarket MAF sensor ($300.00 vs $600.00) for the previous repair of a P0102 code. Light stayed off a couple weeks however the Maf was the... Trouble codes: P0172 (Rich bank 1), P0175 (Rich bank 2).
6
1994 Dodge Stealth 3.0L Misfire VIN: JB3AM44H5R
This was my first time asking for help and it was a learning experiance. I should have started out saying vehicle had been in storage for several years and the plugs,wires cap and rotor were done before we got it. I want to thank all for the help suggestions. ...
11
1996 Dodge Stratus 2.4L Poor Idle Quality VIN: 1B3EJ46X9T
I want to thank everyone who took the time to rspond to my problem. I ended up replaceing the cat and front O2 sensor. Nothing changed with the rough idle and fuel trims after resetting adaptives with the DRB3. Also checked which was mentioned was individual i...
21
2003 Dodge Intrepid SE 2.7L Starting VIN: 2B3HD46RX3
This one is fixed. Andrew was correct, it was a rubbed through wire under the hood. As the harness turns to go around the PCM is where it rubbed through. Thanks everyone
4
2003 Jeep Liberty Sport 3.7L unknown leak VIN: 1J4GL48K03
Thanks to all of you that replied. What we ended up finding was that the reman. A/C compressor was leaking where the two halves come together in the rear. We couldn't get dye to be visable, but used the sniffer to find leak. I don't know why dye wasn't visable...
15
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next