Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for October 14, 2011
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for European
Help Request Answers
2002 Audi A4 Quattro 1.8L Mechanical VIN: WAUAC48H84
good mprning all. i have this pain in my neck audi with bad front trans pump.pump is stuck in the housing.all screws out,left axle out and it mooved 1/4 of inch. please help befoure we brake this thing. thanks
View
2001 Saab 9-5 SE 3.0L Piston VIN: YS3ED48E31
We just removed this engine to replace noisy timing chains, and since its a turbo, we took off the oil pan to clean the oil pump screen. We found a mall piece of # 4 piston skirt in the oil pan. We cant see how it happened or why it happened. It does not seem ...
View
2006 Volkswagen Jetta TDI 1.9L No Start VIN: 3VWST71K96
This vehicle was towed in as a no start. Would start and run for a couple of seconds then die. Attempts to start again would result in cranking but no fire. Wait a minute and it would start and run for a couple of seconds. Checked primary pump fuel pressure an...
View
2008 Volkswagen Jetta SE 2.5L Abs Pump Fault 01276 (V64) VIN: 3VWRZ71K18
Hello, Can someone point me in the right direction, ABS fault code 01276 V64 Hydraulic pump? Cannot find any info on this fault. Any info would be helpful. Thanks, Mark
View
1998 Volvo S70 2.4L Clutch VIN: YV1LS5546W
Please help! Car came clutch pedal broken we replace new clutch pedal, clutch master cylinder.After that car can start with out press the clutch pedal and will start at any gear. We replaced new clutch safety swith but it not help! please help me what I need t...
View
2005 Volvo S40 i 2.4L No Start VIN: YV1MS38295
Thank you for reading this. This s40 will not crank. If we jump the starter with the key on, it will start and run fine. We checked for codes with scan tool, and we cannot communicate with the CEM, AEM, ICM, AFM, SWM and some other modules; some on the high sp...
View

Fixes & Summaries for European
Fix/Summary Answers
2001 BMW X5 4.4i 4.4L battery VIN: WBAFB3351L
Hey everyone! Thank you all for the great help. I replaced the final stage resistor and the car has not yet returned to the shop. Thanks again.
13
2006 Mercedes-Benz ML350 3.5L Esp VIN: 4JGBB86E96
First of all I want to thank the 3 members that answered.I noticed while I was sitting in the vehicle,scanning it,trying to reset zero position that the gear lever looked higher than normal,then I noticed that the signal arm was lower than usual.I proceeded to...
4
2006 Mercedes-Benz ML350 3.5L Glass VIN: 4JGBB86E26
Used PROGRAMA software to scan REDM (Rear Entry Door Module). Had low voltage fault code. Cleared fault codes and reset. Thanks guys...system is working well.
2
2008 Mercedes-Benz E350 3.5L Compressor whining sound VIN: WDBUF5LX58
Are the tools and parts for this available? Owner has not called back, so I'll close for now,thanks for the help.
7
2007 Mini Cooper S 1.6L Cooling Systems
Thanks to all 4 replies for the info on this type of T-stat. We ordered an new OEM one and BMW coolant. I pulled the old thermostat out and ohmed the heater, it was open. Replaced T-stat and filled and bled system Codes are now gone. Thanks again for the helpf...
5
1988 Rolls Royce Silver Spur 6.7L No Start VIN: SCAZN0342T
I would like to thank Cedric&Ted for the info. Changed both relays,(eng run senser&inhibit relay), When pulled you can see the discolored pins. Car starts up fine now. Thanks to all that that replied.
6
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next