 Prev |
Professional Automotive Repair Technical Discussions for October 3, 2011 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 1999 Honda Civic DX 1.6L Misfire VIN: 2HGEJ6612X pulled valve vover and checked for week valve springs. No week valve springs. Trouble codes: P0301 |
View | |
| 2003 Honda Accord EX 2.4L Excessive Emissions, Poor Idle Quality, Hesitation, Poor Fuel Economy, MIL Lamp on VIN: 3HGCM56373 This honda came from another shop. They replace used engine. Runs rough and rich. There is code po122,po108,po113. Replaced map sensor from old engine. Did not make any diference.remove spark plugs all plugs were black runs too rich. No response on throtle. An... Trouble codes: P0122, P0108, P0113 |
View | |
| 2002 Hyundai Elantra GLS 2.0L Shifting VIN: KMHDN45D72 Two days after changing the transmission fluid with Hyundai SPIII and replacing the front brakes and cv axles, the transmission started shifting very harsh, both upshifts and downshifts. The mil is not on, but I can't check for codes because the ecm will not c... |
View | |
| 2006 Kia Optima LX 2.4L MIL Lamp on VIN: KNAGE12386 We checked the Oil Control Valve and it appears to be operating (we pulled out and inspected no debris on the valve and actuated it manually both out of the car and with it running. Note engine did die at idle.)Internally this engine is clean after we pulled t... Trouble codes: P0011 (a camshaft position-timing over-advanced or system performance bank 1) |
View | |
| 2002 Mazda 626 LX 2.0L Trans VIN: 1YVGF22C12 When in drive or reverse there is a loud constant clicking noise from the left front axle input area. This will do it on the rack while brakes applied and steering wheel in any position. We replaced the axle with a new axle with no change. Replace the trans wi... |
View | |
| 2008 Nissan Altima S 2.5L master cylinder VIN: 1N4AL21E38 The problem started with a sinking pedal, we install an aftermarket master cylinder and bleed the system the old way rr lr rf lf stll no pedal, Replaced the master cylinder again, and this time we bleed the system with a vaccum tool,we got two wheels to work b... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 1990 Nissan Pathfinder XE 3.0L starting system VIN: JN8HD17T0L Thank you to all that replied. We found that it had a old aftermarket alarm system installed. Prior to removing it we found that the fusible link was burned out. It went from the battery then from their it goes to the ignition(black/yellow wire)by the steering... |
6 | |
| 2003 Toyota Camry LE 2.4L Mechanical VIN: 4T1BE32K33 Thanks guys for the quick responses. I took the valve cover off and got to one of the head bolts and found that it was loose. We removed the head and replaced all the head bolt threads with time serts. Both the block and head were flat. I ordered the kit loc... |
14 |
