|Prev||Professional Automotive Repair Technical Discussions for August 13, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1999 Ford Taurus LX 3.0L power steering
I am trying to figure out what I did wrong on my diagnosis. This Taurus came in with no power steering assist. This car has only 30k miles on it. The fluid was a little low but not enough to cause an issue. I pressure tested the system to determine the problem...
|2003 Ford Focus ZX3 2.0L MIL Lamp on VIN: 3FAHP31383
I cannot get the my scanner to read the codes. Checked the 12 volt and the grounds. According to the wiring diagram on Mitchell I seem to be missing the computer data lines for the PCM. In the connector I dont have the Blu/red at #14 or the Gry/Red and #6. I d...
|2010 Ford E 350 SD 5.4L MIL Lamp on VIN: 1FBSS3BL9A
Last week it come in with code p1450 and lean code b1.looking at the scan data the tank pressure read 2.75 vdc.i remove the gas cap and it drop to 1.25,put the cap on and reading goes up again.i disconnect the vent solenoid wire connector and nothing happen. I... Trouble codes: P1450 (Unable to bleed up/fuel tank vacuum), P2196 (O2 signal biased/stuck rich b1), P2198 (O2 signal biased/stuck rich b2)
Fixes & Summaries for Ford
|2003 Ford F-550 Super Duty XL 6.0L low power VIN: 1FDAF56P83
replaced tank,pump, filters, and all 8 injectors also reflashed ficm to update injectors on cold stank thanks for all input
|2005 Ford F-250 Super Duty Lariat 6.0L Limp Mode VIN: 1FTSW20P45
As you all know the 6.0 leaker power joke is a problem child. I too figured it to be the solenoid or the turbo. Unfortunetly I am not working on this becasue it is under warranty. Ford corporate says that they support their dealer mechanics and the tech help d...