|Prev||Professional Automotive Repair Technical Discussions for June 11, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|2005 Ford F-250 Super Duty FX4 6.0L MIL Lamp on VIN: 1FTNF20P33
Customer brought the truck in with a mil light on. when we plugged in to the truck found all but 1,2,and 6 with cylinder low circuit voltage. Not sure where to go from here. Any help would be appreciated. Not sure what the FICM MPWR voltage should be with the ... Trouble codes: P0267, P0270, P0273, P0279, P0282
|2008 Ford F-350 Super Duty XL 6.4L engine VIN: 1FTWW31R08
engine has a knock almost like lifter noise all the time no codes runs fine other than the noise dont have much knowlage of deisel engines this a friend of the boss so i was asked to look at it
Fixes & Summaries for Ford
|1965 Ford Mustang 4.7L Poor Idle Quality, Hesitation, Cuts out, Stall VIN: 5F9A703942
Thanks for all the help gentlemen.The problem was the gasket under the pcv plate.I got out the smoke machine like i should have done originally and smoke came out the driver side of the carb plate. I had replaced this gasket when I reinstalled the carb. When I...
|1996 Ford F-350 XLT 7.3L Reverse VIN: 1JFTJW36F3
thanks to all the replied. In my origanal post I mentioned that there was two missing check balls in the worm tracks upon disasembly. There was actually only one, and come to find out,it wasn't missing. Just not supposed to be there. All my manual showed that ...
|2004 Ford Freestar Limited 4.2L Outlet temperature VIN: 2FMDA58224
I found that the 5v reference from the control head/module was only .4v. There was a pin fit issue at the connector on the back of the control head which fixed the problem. Thanks to all who helped.