Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for June 8, 2011
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2001 Chrysler PT Cruiser 2.4L No Start, Cuts out VIN: 3C8FY43BB1
hey techs, have a real headache on my hands. original complaint was that the car dies driving down the road, tach, speedo drops out. pulls over and will not crank. you have to wait several hours before it will crank and start up again. got the car, did not tes...
View
1982 Dodge D350 5.9L engine cooling VIN: FB46598150
Remanufactured engine #2 same as reman engine #1 idles cool 180-190 Run engine at 2000rpm for 5 minutes and engine temp raises to 250f degrees Tried fixes have been 2 engines, 2 radiators, 6 thermostats, 4 water pumps, upper and lower hoses, cooling fan upg...
View
1999 Dodge Durango 5.2L Mechanical VIN: 1B4HS28Y4X
After replacing the evaporater when on ac or max ac the air comes ou of the floor more than the panel. I searched archives and found a couple posts about the rod or bolts on the actuator coming free. I did remove the box again and found these problems. Reassem...
View
1999 Dodge Grand Caravan SE 3.3L Vent temp. VIN: 1B4GP44GXX
This van cam into the shop for what I thought would be a routine A/C service. The customer stated that the system worked fine last summer but slowly stopped blowing cold air. I though it was low on freon from how he described the problem. I connect my gauges a...
View
1999 Dodge Durango 5.9L Low Compression VIN: 1B4HR28Z2X
Vehicle towed in after overheat and not running. Vehicle was disassembled and both heads were cracked. Customer decided not to do repairs and shop owner bought vehicle. I was elected to reistall heads...After engine was reassembled..vehicle started and ran bad...
View
1999 Dodge Intrepid ES 3.2L Reverse VIN: 2B3HD56J8X
I have a 1999 Intrepid with an autostick trans. when I put it into reverse, I feel it engage but when I step on the gas, it wont move (Feels like it is in neutral). The shifter is a little stiff but it will go into drive, neutral and park OK. Any ideas?
View
2002 Dodge Ram 1500 Truck 3.7L Excessive Emissions, Poor Idle Quality, Stall, Misfire, Poor Fuel Economy VIN: 1B7HA16KX2
I have this truck that has poor idle and seems to be running rich. There are no codes present and no missfires are present during live data scan. It seems to run a little better with the exhaust unbolted but still runs very poor. Fuel pressure is @47psi within...
View
2006 Dodge Charger SRT8 6.1L Hesitation, Surge VIN: 2B3LA73W06
Kind of stumped on this one. Car was towed to our shop from another shop that got it in and replace the fuse box under the hood due to the box melted. It melted around the asd relay fuse. Shop replaced the box and then car would not run right after that. When ... Trouble codes: P0037 (O2 sensor 1/2 heater circuit low), P0051 (O2 sensor 2/1 heater circuit low), P0031 (O2 sensor 1/1 heater circuit low), P0038 (O2 sensor 1/2 heater circuit high), P0058 (O2 sensor 2/2 heater circuit high), P0057 (O2 sensor 2/2 heater circuit low)
View
2002 Jeep Wrangler Sport 4.0L excessive pressure VIN: 1J4FA49S62
I did everything from cleaning fins to installing a new fan clutch but high side pressure is 400-500psi after running only a minute or two.This turns off compressor.This system only holds 2 lbs 4 oz of r-134.Only thing I can think of causing such high high sid...
View
2005 Jeep Grand Cherokee Limited 4.7L tire pressure VIN: 1J8HS58N75
The Service tire pressure system error comes up on the dash and the low tire light will flash at times,the sreen showed that both rear tires were showing no signals, so we replaced both rear sensors, after performing the drive cycle the right cleared out but t...
View
2006 Jeep Grand Cherokee Laredo 3.7L MIL Lamp on VIN: 1J4GR48K46
Hello iATN. I have a 06 Jeep Grand Cherokee w/3.7. This jeep came in here with the MIL on and a p0171&174 were pulled. I smoked the intake and exhaust and of course found nothing. Checked the fuel pressure it was at 52-53 psig with spec being 59+/- 5psig makin... Trouble codes: P0171 (B1 lean), P0174 (B2 lean)
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1956 Chrysler Imperial Crown 5.8L Power Steering
I apologize for the delay in posting. This car is a long-term project with many “issues” We think we have the power steering repaired The flow control valve in the outlet of the power steering pump, was sticking. We freed it up, and so far power assist is much...
12
2009 Dodge Grand Caravan SE 3.3L Win Module VIN: 2D8HN44E19
As advised by those who responded we will be taking car to dealer for reprograming. Vehicle is reprogrammed and works fine Thank You to all that have offered help
5
2009 Dodge Charger SE 2.7L Park lamps VIN: 2B3KA43D79
Thanks for all the replies which were in agreement condeming the TIPM. I replaced the TIPM and this corrected the problem.
6
2001 Jeep Cherokee SE 4.0L Electronic VIN: 1J4FF58S31
This ended up being an internal failure. We lab scoped the input speed sensor and noticed when the light would come on, the signal would disappear momentarily, then come back. A new input and output speed sensor was replaced, as well as the TCM, and the prob...
6
2007 Jeep Liberty Sport 3.7L Compressor VIN: 1J8GK58KX7
Thank you to all that replied. It turned out to be what most suggested which was a faulty A/C control head. Only $44 at the dealer so certainly worth the gsmble. I plugged in the new one and the a/c power light came on immediately. The clutch began to work...
9
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next