Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 17, 2011
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1999 Chrysler Concorde LXi 3.2L cranks, no start VIN: 2C3HD46J5X
this vehicle first started dying while driving,with scan tool showing now codes except cam sensor not switching. replaced cam and crank sensors and vehicle started and tested fine. 1 week later, customer states vehicle runs rough. found tensioner failing and t...
View
1995 Dodge Ram 3500 Truck 5.9L No Start VIN: 1B7MF36C4S
hello to all i have replaced the intake cover on this dodge for a oil leak. I had to remove the injector pump to get to the cover. I did not set the engine to tdc before removing the injector pump, i just marked the pump shaft to the gear with a marker. I have...
View
2001 Dodge Dakota 4.7L Hesitation VIN: 1B7GG22N41
Replaced engine with a used unit , has a hesitation cold only there for maybe about three minutes or so , then the truck runs like a new one. This hesitation was not there with the old engine. We installed all sensors off the old engine including injectors , a...
View
2003 Dodge Caravan SE 3.3L problem to fill gas VIN: 1D4GP25R53
Customer can not fill vehicle up without it shutting off every few seconds.All houses around the gastank looked OK,no damage ,no kinks. We suspect the charcoal canister,but we are not sure.We expect the customer to come back when he will use the gas,to lower g...
View
2004 Dodge Grand Caravan SE 3.3L Poor Idle Quality, Surge, Misfire, MIL Lamp on VIN: 2D4GP44L04
This van was brought to me after another shop determined low compression on cylinder #4 due to carbon build up. They installed new valves and checked the cylinder head over. Also installed new gaskets, plugs, ignition coil, and wires. They say the misfire was ... Trouble codes: P0304 (Cylinder Number 3 misfire.)
View
2005 Dodge Magnum R/T 5.7L rear hatch VIN: 2D4GZ58275
Magnum rear hatch has a mind of its own. Sometimes, but not all the time, the rear hatch cycles on and off on its own. Usually when either starting the car or unlocking. It may only happen once or it may cycle half a dozen times. Every time I try to test it it...
View
2007 Dodge Charger R/T 5.7L MIL Lamp on VIN: 2B3KA53H87
Hello I need some help with this Charger!! I have smoke the entire system i did't found a leak, I also check the purge solenoid and it seems to hold vacuum!! Trouble codes: P0456, P0457
View
2004 Jeep Grand Cherokee Limited 4.0L Abs VIN: 1J4GW48N44
Customer complaint of random ABS light (C1032, RR wheel). Seems to occur more with damp/wet weather. Scanned, tested, replaced RR sensor/harness. Drove out fine for approx. 2 1/2 weeks then returned, showing up randomly. We did have wet weather during that tim...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1999 Chrysler 300M 3.5L compressor
Thanks everyone, I checked the a/c pressure reading on the scan data and it reads 4 psi. Than I disconnected the a/c pressure transducer connector and it read 489 psi. I replaced the a/c pressure transducer and the compressor came on.
9
2000 Dodge Dakota SLT 5.9L Surge, Stall VIN: 1B4HS28ZXF
THANK YOU AL [...] FOR THE HELP MOST OF YOU WERE RIGHT ON BAD CRANK SENSOR. STRANGE PART WOULD ONLY CAUSE ROUGH RUNNING IN MORNING FOR SEVERL MINUTES THEN BE OK REST OF THE DAY. THANKS AGAIN
14
2002 Jeep Liberty Sport 3.7L cooling VIN: 1J8GL48KXZ
did not get to fix this one most likelyhead gasket rad felt fine by touch temp gun shows temp drop no bubbles in rad tank went to dealer jeep went to the dealer hope to here back and will post the fix
15
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next