|Prev||Professional Automotive Repair Technical Discussions for April 18, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1998 Dodge Ram 1500 Truck 5.2L No Start VIN: 3B7HC13Y2W
ram had no start, no pcm or trans module communication. i tested for powers and grounds to pcm, found all ok and condemned pcm. i replaced pcm, now have proper comm. with pcm and trans, no fault codes on either. i have not cranked to check for start as new pcm...
|2003 Dodge Neon SE 2.0L Stall VIN: 1B3ES56C93
Hi there everyone. I have this Neon in doing some funky stalling. The customer came for me to go on a drive with him. When I pulled it into gear to start maneuvering out of a parking space, the engine idled then began to lug down and shudder severely and was g...
|1997 Jeep Cherokee Sport 4.0L top end VIN: 1J4FJ28S4L
have a customer that said while driving there was a loud pop noise and then valve train noise, almost like a lifter is bad, pull valve cover off looked for bent push rod,backed out rocker bolt, broken valve spring,oil pressure and compression ck to be within v...
Fixes & Summaries for Chrysler
|2004 Dodge Dakota Sport 4.7L ball joint VIN: 1D7HG38N94
well i took everyones suggestion and changed the lower control arm. this was a weird one thanks for all the help
|2006 Dodge Charger SE 3.5L Misfire VIN: 2B3KA43G96
Thanks for the info guys. This was my first time replacing a PCM using the StarScan. It was very easy. Put the PCM in, downloaded the PCM calibration on the StarScan, loaded file onto the PCM, then went to the WCM and selected "PCM Replaced", then put in the P... Trouble codes: P0205, P0305.
|2003 Jeep Grand Cherokee Limited 4.0L does not shift out of first gear VIN: 1J4GW48S13
I recieved several replies and closed this post but must have hit a wrong key somewhere down the line. I took the car for a ride with the scanner on it. The desired governor pressure was 0 and actual was 235. This is proof that the governor is malfunctioning. ...