Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for April 11, 2011
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2007 Chrysler Sebring 2.4L No Start, MIL Lamp on VIN: 1C3LC46K97
Car sitting on lot starting fine. Customer orderd a used door started fine for two days. Now will not start. No fuel pressure and no injector pulse. Cant make any work with scan codes and can cummincate with all modules. Will run with thrott...
2006 Dodge Ram 1500 Truck SLT 4.7L compressor
Have a dodge pickup here that the a/c compressor runs constantly.With the control panel on or off it runs.Never cycles and eventually freezes up. Even with the control panel unplugged the compressor runs. When I tried to actuate the compressor with the scan to...
2008 Dodge Caliber R/T 2.4L Lighting VIN: 1B3HB28B38
Car came in, when engine running or key is on rear stop lights including high level light flashing like strobe lights, check all grounds circuit & left side wiring under car (Because car had accident on left side) ok, replace TIP module, worked fine for 4 days...
2004 Jeep Liberty Sport 3.7L Transmission VIN: 1J4GL48K94
No codes with this one. Transmission fluid level was over-full. Corrected level. Condition of fluid good; no odor and colors good. Shifting from 2-3 and 3-4 good. Taking off from a stop in first on a slight grade the transmission will clunk into gear. Slips fo...
2008 Jeep Wrangler Unlimited Rubicon 3.8L ABS light, traction control light VIN: 1J8GA69168
Help, I have a 2008 Rubicon Unlimited with ABS, traction control light & ESP light coming on & staying on. I have 2 codes present at this time, C2114 & U0125, low voltage to Dynamics sensor. I have replaced the dynamics sensor & codes came right back on. I hav...

Fixes & Summaries for Chrysler
Fix/Summary Answers
1991 Dodge Stealth R/T 3.0L Excessive Emissions, Poor Idle Quality, Hesitation, Poor Fuel Economy VIN: JB3XD64B7N
Finally got a good ecu. fixed wires that were shorting out the ecu reset the timing car came alive and the nightmare is gone thanks for all the input Trouble codes: 14 (tps out of range), 41 (Injector circuict problem).
1999 Dodge Durango 5.9L No Start, Cuts out, Stall VIN: 1B4HR28Z5X
hello all-i just have to say this site is great. i can not believe i recieved 15 replies. i disconnected the crank angle sensor when the stall happened this monday a.m.(i knew this durango was waiting for me all weekend) and did not get communication back. SO....
2001 Dodge Grand Caravan Sport 3.3L Cuts out, Misfire VIN: 1B4GP44311
sorry for the late close. i did fix this van. the problem was in the hole the crank sensor went into. jasper painted it and the senor would not sit straight in its hole. i could duplicate by pushing on the sensor. cleaning off the paint fixed the problem. than...
2006 Dodge Magnum SRT8 6.1L abs,passeneger seat module VIN: 1G8AL52F86
the passenger seat occupancy nodule problem was a weight sensor shorted taking out the 5 volt reference line.the abs module problem was a bad connection on the module connector.was thinking both items were related because they both happened after an accident,p...
2007 Jeep Grand Cherokee Limited 5.7L MIL Lamp on VIN: 1J8HR58227
Sorry for the delay. I posted this originally for a tech with the agreement he would close it when he resolved the problem. We reconfirmed that we had good fuel pressure and no vacuum nor exhaust leaks. We then questioned our customer as to there fuel fill... Trouble codes: P0171 (Bank 1 Lean), P0174 (Bank 2 Lean).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next