|Prev||Professional Automotive Repair Technical Discussions for April 6, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2004 Chrysler PT Cruiser Limited 2.4L Code set VIN: 3C4FY58804
This vehicle came to us from another shop with both P0218 (High temp operation activated) and P0714 (Trans temp sensor intermittent) set. Cleared codes and monitored trans temp and eng coolant temp. Both operated normally until shortly after trans temp sensor ...
|2005 Chrysler 300 (Car) C 5.7L No Shift VIN: 2C3AA63H65
If there is a Chrysler Tech. available, Have I got a Sob story for you, have your Cryin Towell Handy. I'm not much on Transmission's anyway, but this snuck in as a driveability issue, in that the complaint was "It won't go over 35 M.P.H." I've read that these ...
|1992 Dodge Stealth R/T 3.0L Misfire VIN: JB3XD64B2N
Car came in missing on rear 3 cylinders. Replaced spark plugs. Same thing. Using noid light I have pulse on all 3 cylinders and is firing on those 3 also. Replaced ecu with no affect. When first started in the morning it works fine for about 15 seconds then gr...
|1998 Dodge Intrepid 2.7L No Start, Poor Idle Quality, Cuts out, Stall VIN: 2C3HH46R0W
After a hot soak of 15-20 minutes the car will start and stall, start and idle rough for 10 seconds (and clear out) or not start at all until it cools down. The engine fans work, the coolant temp is not higher than normal, i have drained some of the fuel and a...
|2003 Dodge Caravan Sport 3.3L hvac air circulation VIN: 1D4GP25R93
Vehicle came in with complaint of noise when operation door position control and not enough defrost heat. We saw the mode actuator was operating but the teeth from the upper lever were out of position therefore the noise clicking when moving , removed actuator...
Fixes & Summaries for Chrysler
|2008 Dodge Ram 2500 Truck SLT 6.7L MIL Lamp on VIN: 3D7KS28A38
Closing with a fix thanks for the help. The procedure is to switch on press brake pedal twice then press the gas pedal twice and then switch off. Thanks for the help called and talked to Chrysler tech and he give me the procedure..