|Prev||Professional Automotive Repair Technical Discussions for February 12, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1998 Ford LT8501 LOUIS 8.3L Vibration VIN: 1FDZW86E5W
Truck came in with the throttle linkage broken. we removed and replaced with new It only lasted a short time before it rebroke. This time we reenforced the linkage before installing it. The truck return hours later with a violent shake at 2000rpm. most likely ...
|2000 Ford Taurus SE 3.0L noise and engagement concern VIN: 1FAFP55U8Y
Hoping you transmission gurus can help me here.I have an issue with a buzzing noise at times and a no/very slow engagement problem in both forward and reverse.I got this car from one of my high school students who had driven it with a trans cooler line connect...
|2002 Ford E-350 Econoline 7.3L MIL Lamp on VIN: 1FDSS34F72
Hello technician out there.this is my cry for help I have 7.3 in my shop For a week now that I'm still trying to figure the cause of lock pwr.Here the Store goes,cust just bough this Ambulance & was referral to me. Cust states Vehicle has a lock of pwr,I verif... Trouble codes: P1211 (I.c.p above below)
Fixes & Summaries for Ford
|2001 Ford Excursion Limited 7.3L No Start VIN: 1FMSU43F41
Thanks everyone for all the imformation.The owner has desided to not fix it.He went and ordered a new suburban.Again thanks for all the information.JGS
|2008 Ford Fusion SE 3.0L No Start VIN: 3FAH407198
YES. FINALLY THIS VEHICLE IS FIX. THE PROMBLEM IS COIL BURNED AND IT'S CAUSED THE PCM BURNED TOO. ECM UNDER WARRANTY BY FORD. THANK YOU TAKE TIME TO UNDER HELP ME THIS Trouble codes: P0351 (p0356-), P0356.
|1994 Lincoln Town Car Signature 4.6L Valves VIN: 1LNLM82W7R
Thanks for the help guys. Most of you confirmed that the timing chain has probably jumped time and done damage to the valves. I've recomended a valve job to the customer, but he is still undecided at this point. Unfortunately I'll have to close this request wi...