|Prev||Professional Automotive Repair Technical Discussions for December 18, 2010
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1988 Dodge W100 Custom 5.2L start & stall when l VIN: 1B7HW04Y2J
the problem is when i start truck runs until i let off key. has no ballast resistor i thought it was a bad ecm so replaced no luck.didnt think pick up was bad test lite blink ok on coil.havent work on many old dodge pick up could use a little help if your fami...
|2000 Jeep Grand Cherokee Laredo 4.0L Misfire, MIL Lamp on VIN: 1J4GW48S5Y
OK , Im stumped . i was a jeep tech for 10 yrs and had seen many 4.0l cyl heads cause this issue . the cust states ck. engine light is on with no driveability symptoms . ck and found codes for misfire on all cyls . cleared codes and road tested . on a long sli... Trouble codes: P0300, P0302, P0303, P0305, P0306
Fixes & Summaries for Chrysler
|2005 Dodge Sprinter 2500 2.7L No Start VIN: WD0PD74455
Thanks to everyone for the assistance ! the relay was located in the side fuse panel of the drivers seat . its yellow in color . one of only two relays in that box . found one terminal pin for the relay was not secured in the box and was making minimal contact...