
![]() |
Professional Automotive Repair Technical Discussions for November 29, 2010 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Chrysler
Help Request | Answers | |
1999 Chrysler Concorde LX 3.2L Computer Engine System VIN: 2C3HD46J8X Vehicle is not starting, and there is no communication between scanner and engine. I am using a Snap-on MODIS Scanner, when connected it to this vehicle, it will communicate with everything except Engine. Under Body Control Module information, through scanner,... |
View | |
2005 Chrysler 300 Touring 3.5L numerous VIN: 2C3JA53G55 The lights pulsing seems to last for 10 seconds or so when first started cold, then it stays steady it may or may not pulse again if the car sits for several hours. Since replacing the alternator the pulsing will now int happen while driving and also seems to ... |
View | |
1995 Dodge Ram 2500 8.0L reverse VIN: 1B7KF26W5S this truck is a night mare it came in originaly with a now moving complaint found burnt od clutchs and other burt parts replaced all bad parts reinstalled left here with no problems truck came back a week later no reverse pulled down valve body air tested forw... |
View | |
2004 Dodge Ram 1500 SLT 5.7L No Start VIN: 1D7HU18D14 Hello all again. This truck came as major collision repair and a no-start. I'm unsure the extent of the repair, but I have a no-crank condition. The PCM isn't grounding the starter relay. When I bypass the relay I still have a no-start condition. My red led in... Trouble codes: P0513 (No Skim Key / Skim error) |
View | |
2004 Jeep Grand Cherokee Laredo 4.0L Excessive Emissions, Poor Idle Quality, Stall, MIL Lamp on VIN: 1J4GW48SX4 We have this Jeep that came in for a low idle and stalls at stop cold. It would idle rough on first start in morning but would clear up after it started to warm up a few minutes. I also now have a code p1686 for "no sentry key immobilizer bus message" and at t... Trouble codes: P0171, P1686 |
View |
Fixes & Summaries for Chrysler
Fix/Summary | Answers | |
1988 Jeep Wrangler Laredo 4.2L Poor Idle Quality VIN: 2BCCV8145J Hey everyone...sorry for the late post, I ended up ordering a reman. carb and this fixed the problem. I couldn't find a replacement sol-vac valve so I left it off when I installed the new carb and it seems to work fine. I was going to rebuild the old carb but... |
8 | |
1989 Jeep Comanche Pioneer 4.0L No Start VIN: 1J4FT37L8K I want to thank all who responded. There were alot of good suggestions. There was a suggestion to lower the crank sensor and replace the wiring harness from the crank sensor to the computer. We did lower the crank sensor and the harness was replaced, but it st... |
7 | |
2003 Jeep Grand Cherokee Limited 4.0L transmission VIN: S83C542292 It was stated "that it sounds like the parking paw is not releasing". We,ll that was cause of the noise. After taking the OD unit off the transmission we found the Over Drive clutch Wave Spring had broke into 4 pieces. The pieces were projecting out from the O... |
6 |